Thanks, my vehicle has a similar problem with all the different warnings lights on. I’m glad it might be a sensor.

@OurSimpleAdventures

3 жыл бұрын

You're welcome and thanks for the nice comments. Please Subscribe & hit that notification bell! Good luck!

You are wrong here the whole steering column does not need to be removed you just need to remove the steering wheel then the clock spring and it’s attached to the back of the clock spring

@OurSimpleAdventures

3 жыл бұрын

Thanks Barry!

my 2005 Audi A8L has steering angle sensor voltage supply terminal 30 and front passenger wheel speed sensor faults. The steering angle reset requires VCDS which I don't have

@OurSimpleAdventures

3 жыл бұрын

Interesting. Thanks so much for the comment and info! Please Subscribe and hit that notification bell as there will be more!

Great video thanks

@OurSimpleAdventures

9 ай бұрын

You're welcome!

I had my left axle replaced and I noticed the steering wheel was not aligned and as I drove home the Jeep made this rumbling noise and immediately the ESP BAS and traction sensor illuminated on the dashboard. My question is could the replacement of the axle damage the Steering Angle Sensor? Any feedback would be appreciated.

@OurSimpleAdventures

4 жыл бұрын

Did you take it back to the person who replaced the axle? It could have caused it.

@TheGeno2001h

3 жыл бұрын

I replaced the tie rad yesterday and the light turned on so it’s not always the angle sensor

@BrendonR.B

Жыл бұрын

You need to replace your clock spring, it's cheaper when u buy it and get a mechanic to put it in, rather then tge garage.

my traction control light went on after changing my steering wheel.. and scanner says it’s angle sensor. My question is angle sensor mounted on clock spring?

@OurSimpleAdventures

4 жыл бұрын

Yes I believe it is but I haven't replaced it yet. When I do I'll post a video. Thanks for the comments. Give us a follow and Subscribe as there will be more!

My 2013 Suburban LTZ has the traction control light and the service stabilitrak light on. Many people advise me to check the steering position sensor connector. Theres mention of putting a foam spacer to keep the connector from leaning over and to prevent corrosion?

@OurSimpleAdventures

10 ай бұрын

Thanks! Master Mechanic?

I have a 2010 dodge Journey ESP/BAS and traction lights come on at random which is causing my car not to shift out of park when lights are on. I have to shut my car off and turn back on to get lights to shut off and able to shift out of park any advice?

@OurSimpleAdventures

3 жыл бұрын

Thanks for the question. Heff any ideas?

This guy is making big money off you just being a mechanic & listening to his lingo is hilarious

@OurSimpleAdventures

2 жыл бұрын

Right. Lol Thanks so much for your intelligent comment!

I have abs, esp bas and tc lights on thinking thats my problem too..i read on a jeep forum that it may be able to re calibrated?? Doesnt hurt to try. Then go from there

@OurSimpleAdventures

4 жыл бұрын

Hmm let us know how that goes Andrew. Thanks for the comments! Give us a follow and Subscribe as there will be more!

@CliffMcLarnon

3 жыл бұрын

@@OurSimpleAdventures Good day sir,just wondering if that could be the problem with my 2009 Jeep Comander,all 3 lights are on,(ABS,Trac. cont. and ESP)But sometimes they go away,but comes back on..Strange.Thank you so much..✌

@OurSimpleAdventures

3 жыл бұрын

@@CliffMcLarnon Hi Cliff, It definitely could be but I'll let our Master Mechanic answer that if he is still watching. Eric?

Thanks

@OurSimpleAdventures

4 жыл бұрын

You are welcome! Give us a follow and Subscribe as there will be more!

Can code C121C (Torque Request Signal Denied) be caused because of code U0126 (Lost Communication with Steering Angle Sensor)? I do have code C2100 (Low Battery Voltage) And i have been told that my car seems to have a shortage somewhere because the lights dim when we ran an alternator test (good) and battery test (bad which was replaced) when i turn my steering wheel all the way to either side, it makes a nasty noice that seems to come from the power steering pump. I also have problems with my blinkers and my headlights be glitching at times. Sometimes i have my car on idle and they flick even my dashboard so i know it’s something electrical. The history with this car (2005 Chrysler 300 5.7L V8) is that it had a bad heater core so they ended up replacing it.

@LuisMunoz-jc1pi

3 жыл бұрын

I also have my airbag light on...

@OurSimpleAdventures

3 жыл бұрын

Hi Luis, I'm going to leave this for my Master Mechanic or whomever else might be able to help you. Thanks for the question! Please Subscribe & Hit that Notification Bell as there will be more!

@OurSimpleAdventures

3 жыл бұрын

@@LuisMunoz-jc1pi Wow a Christmas Tree!

@LuisMunoz-jc1pi

3 жыл бұрын

I only have CEL and the airbag light on. Not even the ABS light on. I had to scan it to see the codes on my own

@OurSimpleAdventures

3 жыл бұрын

@@LuisMunoz-jc1pi Good luck Man! Please let us know what you find as it helps everybody.

HI GUY HOPE U CAN POST THIS CAUSE I AM COMPUTER CHALLENGED. 2009 CHALLENGER MANUAL TRANS. ESP BAS LIGHT CAME ON WHEN TIRE CAME OFF CURB OUT OF GAS STATION RAMP N TIRE SPUN.ESP (ELECTRONIC STABILITY CONTROL)BAS(BRAKE ASSIST PROGRAM) I DID ALL THE TRICKS ON U TUBE. SPIN WHEEL ALL THE WAY TO RIGHT THEN TO LEFT. TURNED LIGHT OFF TEMPORALLY. TURNED CAR OFF WHILE IN NUTRAL WHILE GOING 20 MPH N RESTARTING IT. TURNED LIGHT OFF TEMPORALLY. LOOKED INTO STEERING ANGLE SENSOR N FOUND THAT IF THIS HAPPENS TO U , IT SHOULD RESET ITSELF AFTER ABOUT 100 MILES OF DRIVING OR SO.IF NOT,THERE ARE CODE READER DEVICES THAT HAVE SAS ON THEM. THIS RESETS YOUR STEERING ANGLE SENSOR. DO THIS BEFORE CHANGING IT.ALSO WHEN U DO CHANGE IT IT SHOULD BE RESET TO CENTER.

@OurSimpleAdventures

3 жыл бұрын

Thanks Evelyn!

so the angle sensor is mounted on clock spring?

@OurSimpleAdventures

4 жыл бұрын

Yes I believe it is.

Thanks for that I just change rack and pinion so after that the code c0d35 steer wheel sensor signale implausible

@OurSimpleAdventures

2 жыл бұрын

Thanks sangwa!

Did the angle sensor fix it?

@OurSimpleAdventures

4 жыл бұрын

I haven't done it yet. I will post a video when I do. Give us a follow and Subscribe as there will be more!

He never mentioned the simple reset that the maker suggested to try first

@OurSimpleAdventures

Жыл бұрын

Thanks Eric!

@JohnDoe-en9ch

6 ай бұрын

He can't overcharge you that way.

I'm having similar issues with my 09 caravan and the dodge dealership wants big money to fix it, so i solved the problem by trading it in for a toyota lol

@OurSimpleAdventures

2 жыл бұрын

Haha! Thanks for the comment!

Did you say he does mobile diagnostics?

@OurSimpleAdventures

3 жыл бұрын

Go ahead and call him. He'll help you if he can!

Are you in Canada or USA?

@OurSimpleAdventures

3 жыл бұрын

USA Arizona

I have a c2200 & c2205 code

@OurSimpleAdventures

4 жыл бұрын

Sounds like same thing then. Give us a follow and Subscribe as there will be more!

PLEASE READ: they guys in this video took the expensive way out although the video was informative. Look for my name and video on a cheaper way to fix the problem.

@OurSimpleAdventures

3 жыл бұрын

Ball joint? I didn't know the ball joint had a sensor attached to it. Thanks for the comment though!

Master mechanic lol

@OurSimpleAdventures

Жыл бұрын

He is good!

Bloke is a bullshitter, you are being had over, remove steering column, lmfao

@OurSimpleAdventures

4 жыл бұрын

Haha! You think? I'm going to disagree. Thanks for the comment! Give us a follow and Subscribe as there will be more!

A master mechanic but doesn't know the order of the letters for the service light 🤦

@OurSimpleAdventures

2 жыл бұрын

Thanks for the comment!

This why i hate mechanics. Always exaggerating the fix. Im gonna have to open a shop and though i may not be profitable to be rich, i can gain business by being honest!! The whole thing dont come out. Just steering wheel and clock spring. Its on back if clock spring. Whole column my butt!! 😆

@OurSimpleAdventures

3 жыл бұрын

Thanks for the comment D Roc!

Completely wrong....

@OurSimpleAdventures

Жыл бұрын

You think?

@C-TOWN-ALL-STAR

10 ай бұрын

​@@OurSimpleAdventures He's Abso-EFFIN-Lutely correct about it being 100% WRONG & DECEPTIVE 💯 ☝😎☝

@OurSimpleAdventures

10 ай бұрын

Thanks! @@C-TOWN-ALL-STAR