Masking on Canvas - Using Masking Tape and Masking Fluid
How to use Masking Tape and Masking Fluid when painting on canvas with Acrylic paints. This technique will allow you to preserve edges and details.
Music: Beautiful Haze - Licensed through MotionArray.com
Пікірлер: 18
Hey Mark, great practical and informative video. Thanks for making it!
Really clear instructions. Thank you so much for de-mystifying this topic!
@stewartcameron3699
10 ай бұрын
😊
Well done. You have answered all my questions about masking and blending
1/8 or 1/4" blue striping tape is good for tight or complex curves. It can be made less sticky by applying a very light coat of talcum powder to the sticky side. Put a small amount like a tsp in a saucer and pick up a little on your thumb and rub it gently on the tape. You can also with a sharp knife slice thin strips of the Frog tape to use as striping tape. If the striping tape is too thin you can double it and or use full width tape in addition. Once you've got your curve with the striping tape the full width tape is easy follow the curve of the thinner tape.
Great tutorial!
Great video.. thank you 😊
Very good video. Thank you.
Thank you, I’m going to try this
Tyvvvvvm🥰😍👍👍
thx
wondering if i can use clear gesso as a temporary stencil. i use temporay stencils if i airbrush over the stencil or underit will it stop paint bleed on canvas??? please advise
Great video! I have a question I been using masking fluid on my canvas when I peel it off little bits are stuck to the canvas and I can’t seem to get it off how do I remove this and can I varnish over there bits when the painting is dried? Thank you
@markbenavidez356
3 жыл бұрын
The trick to masking fluid is to remove right away. That's why I peel while the paint is still moist. If I get some stuck I use a pencil eraser to remove it. Rubber cement thinner works too, bit it'll dissolve your paint too. What type of masking fluid are you using?
@carlosstfc321
3 жыл бұрын
@@markbenavidez356 thank you for replying, I’m using the same as you. My painting is pretty big 30 x 40“ and I masked off my little subjects to put the background and I can’t get tiny bits off I have tried everything I have, rubber knifes pallet knife water and still there You think I should remove it before varnishing my painting or is it okay to leave the tiny bits on Thank you
@markbenavidez356
3 жыл бұрын
@@carlosstfc321 being a large piece you may be able to get away with leaving it and varnishing over. If it were a smaller piece or if the texture was in a focal point I'd sand it down a little then retouch it.
@carlosstfc321
3 жыл бұрын
@@markbenavidez356 thank you do you have IG so I can show what I’m dealing with :)
Tyvvvvvm🥰🥰🥰👍👍👍