***PARTS LIST*** 1x Table-Top material of your desired type and size .....I used 1.5-inch thick Acacia Butcher Block counter-top, 24-inch deep x 63-inch long 32x screws of desired type and length (ensure screws are suitable length and not too long!) 4x 3-inch diameter self-adhesive felt pads to protect floor 1 can, Black, Hammered Finish, Rust-Oleum Spray Paint (Black Steel Pipes - 3/4-inch diameter) 8x Flange 6x T fitting 4x connector 2x 2.5-inch nipple 4x 4-inch nipple 1x 6-inch nipple 2x 10-inch nipple 2x 12-inch nipple 4x 18-inch nipple 2x 24-inch nipple Also needed are Acetone, rubber gloves, shop rags, thin wire brush, carpet knife (for cleaning the pipes)

Very impressive project. Thank you Todd.

@ToddMcMahon

2 жыл бұрын

Thanks! 🙂

Looks great! Wish I had been there to help you. By the way, that outro is hilarious! 😂 Little bit loud compared to the rest of the video though.

@ToddMcMahon

2 жыл бұрын

Thanks! 🙂 Sorry about the volume difference at the end. I ended up re-making this a few times due to other audio issues (i.e.: noise from the saw drowning out the narration). At the end, I just presumed the outro would be fine, as I have used it several times before, but alas, nope.

@blackdragoninnovations3563

2 жыл бұрын

@@ToddMcMahon it's a great video. It was specifically the high pitch chime at the McMahon logo. On my phone it came out pretty loud. Haven't tried on PC yet so not sure if there's a difference.