Makerbot Replicator X2 PSU Upgrade / Replacement / AC Power
Ғылым және технология
How to cheaply upgrade the Makerbot to not need the expensive Proprietary 4 pin DIN power supply. We replace it with a common closed frame 24V supply mounted underneath the printer, and solder wires directly to the motherboard.
Пікірлер: 6
Is there any chance you may be able to assist me in setting up my Replicator 2X with PrusaSlicer? I have been down a rabbit hole for over a week now and can not seem to find the settings I need. If anyone has a profile for this, please please share. I appreciate any assistance from anyone that may be able to help!
24v 200w how many amps.and did it work as it should
@mrT1179
2 жыл бұрын
And a picture of the underneath of the board would be awesome
@TheMadHatter1337
2 жыл бұрын
200w/24v=8.3 Amps. Yes it works as expected.
@mrT1179
2 жыл бұрын
@@TheMadHatter1337 also what terminals did you solder too I’m still a little up in the air on what ones
@TheMadHatter1337
2 жыл бұрын
@@mrT1179 sorry I sold it actually... So I can't take a picture.