Great video simple and to the point as so many videos I passed on were 11 minutes +. I just blew out my last tip connection yesterday so I figured it was an o ring but was trying to install between the sliding piece and the inner port fighting bearings falling out and such🤦🏻‍♂️ im so ignorant I tried 4-5 different sized orings before getting pissed and throwing a fit, figuring that there was a good chance that I was doing it wrong after calming down last night I decided to check the you tubes and found exactly how easy it is compared to what I had tried. I have been buying o-ring kits to have on hand for a couple of years now and as someone who feels the need to make an effort to repair my own equipment before entrusting to strangers it’s become a standard practice to keep a variety of o rings on hand. Theyre cheap enough where I have bought them so now that I know how simple and quick it is I will start changing them routinely before they wear out. Thanks for the lesson 🙏🏼

This was not helpful....What size o ring???

@GOIndustrial

Жыл бұрын

See the description in our bio - we have links to the O-Rings in both 1/4" and 3/8" depending on the size of your Quick Connect fittings. Typically the fittings are 3/8" - this kit is suitable: goind.com.au/products/graco-o-ring-112-10-pack-17p090

@pfidahospud

11 ай бұрын

@@GOIndustrial $74 for 10 O-rings? You're kidding, right?

@bigboardfun

10 ай бұрын

Check your o ring link it looks like the decimal is in the wring place.

@KimoPollock

Ай бұрын

#5 and #8