Why did I burst out laughing when that water bit you 😂😂 I died. Thanks for the tutorial

@watchmeyodel

3 жыл бұрын

You got one for Christmas too?🤣

@grawakendream8980

3 жыл бұрын

caught us off-guard i guess. i haven't laughed harder in a while

@Eric-si3iu

3 жыл бұрын

Just installed mine and the same sh$t happened to me..lol. Gotta watch out for the spray of water!! Thanks for the Tutorial.

@edgoodwin4389

3 жыл бұрын

Cause it was a genuine reaction 😂

@alexvallejo1553

2 жыл бұрын

That test spray was essential for me to know it works 😂

my mans got attacked at the end!!! LOL

Thank you! It's been sitting here for weeks. Waiting for my husband to install it...... I'm going to do it myself now.

@robertalonzo1569

Ай бұрын

Do it Nikki 👍💪🏻 Just be patient to Not cross thread when you turn the nuts. Do Not put Too much force on the wrench either, kinda turn by hand til snug then about a 1/2 to 3/4 turn more. (If it leaks you can always tighten it a bit more) Keep checking for leaks daily for a week, then once a week. *also periodically, cause sometimes the water company might accidentally bump the water pressure up & that might (might, rare) cause a leak. Good luck. You Can do it.

Test run and it hits the spot… What we’re all looking for in a bidet tutorial.

Thank you for this excellent tutorial. Unlike everyone else I needed to know how to UNinstall one of these things. From my experience I want to caution folks to make sure there are no slow leaks, your point about using the plumbers tape is good. My tenant vacated my rental house and left one of these bidet attachments , immediately I noticed that the toilet was not level. Looking closer I saw that water had been dripping and rotted the floor ! What a mess, and expense ! She was there for five years , unfortunately I don’t think she cleaned the bathroom very often so she probably didn’t notice. I would say, even after you have installed the bidet that it’s a good idea to check periodically for leaks.

Thanks for this! I'm a visual learner and have to see someone actually doing it. Pictures are ok but seeing it in action helps a lot. And that was funny when you turned it on 🤣 I figured that would happen!!

@MrWill1985

2 жыл бұрын

It was funny at the end. I tested mine with the seat down but I had to wipe up water from the floor

4:27 LOL. That made this video. Was not expecting a fact-finding mission to turn into a ha-ha. Thank you! You should put this under comedy for that one! Made my day

@WorldofTech

3 жыл бұрын

Lol

Thanks for sharing. The Teflon tape is for metal to metal threads, also the metal and plastic three way fittings are for 2 different size provisions of your toilet.

Such a well made to the point instructional video. Good job.

Thank you for this! Perfect tutorial. Straight to the point and clear.

Great toot! ……The paper instructions weren’t terrible, but a quick vid to play as I installed was way faster. Super easy to install & the wrenches that came with didn’t even fit. Total process took 10min. This lil’ guide + $30 is quite honestly something everyone should invest in! Thanks for the accuracy & simplicity! Happy poopin’!!

Thanks! You made installation much easier!

thanks for the video. package came with two t adapters, one metal one plastic, instructions only mentioned metal one, didn't know which one to use so came to your video and found out i could use either one. thanks!

Thank you so much! This was just perfect for me; very easy to follow!

Thanks for the tutorial. Although I would suggest dealing with the pipes first before attaching the bidet to the toilet due to the space between the wall and the pipes. An issue I ran into was that my pipe was leaking even though it was closed all the way, and by the time I was able to attach all the pipes together the floor was nearly flooded.

@MrWill1985

2 жыл бұрын

I learned the hard way to install the pipes first but I got mine installed with no issues

I followed you step by step and even screamed when I turned on the water 😂 it was still unexpected

Got it all hooked up with no issues! Thanks so much for the video!

Thank you World of Tech - video still works in 2020! This little lady go the bidet installed in 30 minutes thanks to you!

Started my install trying be to confident with the direction and my water was leaking a bit, I believe it was due to water in my tank leftover (I emptied it as much as I could) but wasn't sure. Thank you for confirming this in the video! I now feel confident to finish the install!

@nenewoods4084

2 жыл бұрын

Me too.

@jordanwolfe800

10 ай бұрын

😊 2:33

I brought mine in 2020 and have yet to install it because of fear, however, you made it look so easy that I intend on installing mine tomorrow. Thank you.

@kendonato1887

7 ай бұрын

well how is it? :)

@lorijones513

5 ай бұрын

Did you install ?

@siasgal62

4 ай бұрын

I tried to install it and there’s a stuck screw and I cannot get it off. I was able to drain the tank, disconnect the water line, and removed one screw and now I’m stuck. I tried to use some tool my daughter let me borrow but it didn’t work. I put everything back together and gave up and now I have a loose toilet seat.😜

Thanks for the install video, going to install one in the apartment soon

Thanks a lot. It really helped. I had to shut of the main because the tap wasn't shutting off. But I did. Yaay..

Thank you! Got it installed in less than 15 minutes!😁

Thank you for doing this! I was wondering about this product. The one I had before needed an outlet and in my development they don’t put them close to the toilet unfortunately

This was actually a very informative review. Nice explaining 💯

Thank you & you showed is in less than 5mins 🙌🏼🙌🏼

Thanks for taking the time to help a brother out!👍

@WorldofTech I usually add a bleach tablet in my water tank. I was wondering does the water to clean you come from the tank or the pipe. If it comes from the tank than I won't be able to use the bleach tablets am I correct?

Great Tutorial! Could not have done it without this video! Thanks a Million!

what did you do with the bolts that were attached to the screws. were those not needed anymore?

Low setting seems strong. What's the high setting for? Enemas?

@WorldofTech

3 жыл бұрын

Lol

@mof2324

2 жыл бұрын

Lmaooo!!!!

@jason5409

2 жыл бұрын

To pop hemorrhoids 😆

I have to get used to the cold water but it does an excellent job.

I don’t have this bidet per se but the attachments are all similar. I have the metal T adapter and now only getting water flowing to bidet and not the toilet. Any suggestions?

I just want to see the way you’re doing your video is perfect. You cut to the Chase you should turn this into a full-time job doing videos the way you do you don’t beat around the bush. You get straight to the fact keep it up. You’re doing a great job.

Thank you! Setting it up today.

Bought a place to live and one of the bathrooms had a bidet. I tried it and I never went back. The amount of toilet paper you will never use again is insane.

I had to rewatch the end. Very funny. Thanks for the video. I think I'm going to get one.

Did your toilet sit close properly did you have to add bumpers to underneath of the toilet sit?

This was amazing 👏🏾 you made this process easier, Thank you 😊 💓.

Thank you so much for the tutorial! Excellent 👍

Very helpful, thanks!

I bought 1 but mine came with a hot water hose and a cold 1 if i just plug the cold 1 on will it spill water through the non attached hose?

Thank you for the video. It’s easy and helpful.

How long were the bolts for the seat? I couldn't get my toilet bolts to reach-- they were too short with the bidet thingy raising things up.

I have a Luxe bidet Neo 320, but I kept putting off installing it. I almost did it last Saturday, but I decided to wait until the maintenance guy was here so that if anything went wrong I could call him up. Unfortunately I would not be allowed to drill a hole to get to the warm water too, but it's nice to know that the cold water can still work and be tolerable.

You made it so easy and quick.

Thank you for making this! It made my installation so easy.

This video helped me out alot ihstalled mines without a problem,thank you

perfect tutorial! didn't even need the sound lol great job filming this

@WorldofTech

6 ай бұрын

Thank you!

Short and sweet. Thanks! I also did the stupid thing and didn't turn it on slowly. Got myself wet lol. You'd think that after seeing you do it I'd keep this in mind. Nope lol. Thanks again!

@WorldofTech

2 жыл бұрын

Lol

Thank you for uploading this information.

Thank you!!! I did it!

Ok, I'm going in! I can't wait.

This whole video was great

Thanks! Just put mine on and you helped.

3:40 did you turn off the valve after the water tank is filled? Thanks for the video, everything else was very clear!

Easy to install, kzread.infoUgkxjA-hDN2m8_mi0Dg0JD8U6QiArozIAc4I and comfortable. No idea what other people were talking about when they said it was difficult to install or uncomfortable.

Appreciate the video! Thank you!

This video was very helpful! Thanks

I can’t get to the water hose attached to the toilet. It’s way in the back. New toilet model. Can I attach the T to the main water line??

Does the seat still sit flat after you installed the bidet ?

That looks like a lot of tension on the water supply line from the wall. Is that OK like that?

That ending "O Shit" made me laugh too hard.

Hey man great video to the point no lag nothing that's the way videos should be done. And your voice sounds like a young Clint Eastwood. 👍🏻

Thank you for the tutorial!

It was really helpful thanks a lot

My toilet has a static pipe, not the flexible kind attached to your toilet. Should I just replace the existing pipe? Any reason for that type of plumbing being done on a toilet?

Thanks for the video and saving my sanity. I came here because I had a leak and only when watching your video did I see that the rubber washer you have in you T piece is missing from mine!

Perfect instructions, thanks!

Thanks for this video! I just finished installing my bidet with your help :D

@WorldofTech

4 ай бұрын

Fantastic!

Put it on and the seat and top don’t lay flat on the porcelain bowl,the thickness of the cleaner makes it so it doesn’t lay flat any suggestions

Thank you!!!

Thanks for the upload. This helped a lot

The ending made my morning, thank you for the laugh hahaha

Toilet seat is now 1" in the air. And when one sits on it, toilet seat goes down and puts pressure on the cover and sprayer no longer works, doesn't extend. Did you have to add bumpers to this? And if yes, do bumpers stay put or fall off?

Ha! Loved the happy ending. 😂

thanks this helped me

Nice and easy. Very good video. What is the purpose of the teflon tape?

@QueenSlime007

2 жыл бұрын

it creates a tighter seal to prevent water leakage. it helps alot

Great video!!!! Very helpful!!

Nice review.👍

Great job!

Huge help!!! Thanks!

Thanks for the video.

thank you 🙏 just installed mine best investment ever

Great! Thanks for the video

Amazing video 👍 thanks

Perfect thank you

Hey! I just found this video along with other videos I missed Didn’t receive it on my notification. This is an interesting review on this gadget for the toilet. So what’s your thought on it since you had it installed.

@WorldofTech

3 жыл бұрын

Let’s put it this is way... I wish I had this years ago. U won’t understand until u actually have one.

Mine doesn't have water pressure like that at all. Also, the nozzle clean doesn't work. Any idea why?

Thanks for the help. Just mounted one on. Its amazing how cold water hurts the culo. Lol

Install was easy but there’s a huge gap at the front of the toilet seat on mine. I’m confused because my toilet looks exactly like the toilet in the video. There’s a solid 2-2.5 inch gap at the front after install . How do I correct this?

Thanks for this

Good tutorial, thanks

Awesome video. You made it look easy and do able . Thank you

Works Great !

Thanks great video

Amazing!!! Amazing!!!

What about your toilet seat. Is it really high up off the toilet bowl?

What kind of toilet is that on the video? Will it fit...glacier bay toilet

Appreciate you, big bro