thank you so much for posting this the instructions stink hard to tell based on the images!!

Thank you so easy 5 minute job🤝

One question that I have that isnt addressed in the directions or comments during the installation. The mounting brackets. Should they be mounted pushed back as far as they can to the window? Or pulled forward to the edge of the window opening? Or centered in the gap? The video makes it look like as far back as possible. But want to verify.

@lumino4734

9 ай бұрын

That would really depend on how you would like the blinds to look into the window frame. You could put the brackets back slightly to create a flushed look with the window frame. Otherwise you could have the brackets set farther back to make the blind look more set back.

You mentioned in the video having to mark where the internal components are, but don’t necessarily give a reason as to why. So I figured out the hard way after trying to install a 72 inch blind myself that the reason to know that is to avoid those areas with the bracket rather than aligning the brackets to those areas. That is not specified in the instructions or this video. Other than that, the blinds work great…

@lumino4734

3 ай бұрын

I am sorry that you encountered an issue. Yes, if brackets are installed in that area, it will prevent the blind from securing with the bracket and could make it not work properly. This mention to not install in the internal components area is stated in the marking screw hole locations.

I installed 6 of the the blinds in upstairs of my home -- took me a bit longer than 15 minutes each. One of them won't go up and down. Is there a trick to get it to work? Nothing in the instructions or video on troubleshooting.

@lumino4734

Жыл бұрын

First I would check to make sure the brackets are not directly next to or on top of any of the internal components in the top headrail. If you are still having issues, please email support@luminodecor.com

would be nice to know what the level is for, etc.

@lumino4734

Жыл бұрын

Pending on how the blinds are mounted, then the level could be helpful.

Same issue as everyone else. Blinds won't snap in place. I've been trying for 2 days.

@lumino4734

Жыл бұрын

Please email us at support@luminodecor.com

These things are a colossal pain in the ass to install! These vertical brackets are crap! I had Real Simple blinds from Bed Bath & Beyond that had a clamping square bracket after the simple 2 screws the brackets opened up and the actual blinds slid in with the greatest of ease! This junk from Vietnam is ridiculously convoluded! In a video from 5 years ago you people clearly knew about those brackets! If you could have them then why not now? I would not recommend these unless you want your friends family and neighbors impressed with your knowledge of certain 4 & 5 letter words! Trying to slide these stupid things into the brackets the plastic got marred! After finally getting them up and looking at them I come to realize the end caps are pushing off, the blinds go up unevenly and have a tilted hang to them the very problem I was trying to get away from, with my corded blinds there is a tremendous amount of slack in the up down cords and they dont go down right anymore! These pieces of junk are going back to Menards I will never buy one of your sub par products ever again, Im getting my money back and going higher quality!

@lumino4734

Ай бұрын

I am sorry to hear that you had a bad experience with our products. Please note that the square backets you speak of work specifically with blinds that have a separate valance to attach which would then hide those brackets. In this case, the valance is built into the blind, so another bracket option had to be found and be hidden. In the case of these blinds, you would not slide them into the brackets, it would be rotated back and into place. Pending on where you notice the tilted hang (if fully extended), then that can happen in transit of the blinds. The blind slides in the box during shipment and can potentially tighen on one side. There is an easy fix for this; full extend the blind, yank harshly on one side, push the blind all the way back up and pull it all the way back down. It might take a few repetitions, but that should fix the issue. If you have any additional questions, you can contact us at support@luminodecor.com.

@user-xo1ej8sb9o

Ай бұрын

@@lumino4734 Well thanks but I returned them They were beveled and bent outwards to boot after I finally got them hung they didnt look right! I went with Levolor didnt have to put any other bracket up I was able to use the existing one they just slid in in a few minutes.

Dident workk for me been 2 days and can’t get em to snap in place

@lumino4734

Жыл бұрын

Please either email us at support@luminodecor.com or call us at 877-687-2796.

@chrisschley4173

Жыл бұрын

I'm having the same problem. Try removing them and reinstalling them!!! Unbelievable, Certainly Not User Friendly. I guess were not alone, look what I have to look forward to.

@lumino4734

Жыл бұрын

@@chrisschley4173 When inside mounting the bracket, are you using the white spacers?

@edwardbryant12

Жыл бұрын

Worst blinds to install ever. I’ve installed blinds so many times but never this hard

@lumino4734

Жыл бұрын

@@edwardbryant12 what issue are you encountering? Feel free to email us at support@luminodecor.com.