So does that mean 406 is a better choice for Nylon 66 / Polyamide ? Thank you in advance.

@henkeladhesivesanz

24 күн бұрын

Hi there, Both Loctite 401 & 406 will provide very good results, but 406 is a little better choice for Nylon. It cures faster and has a higher temperature resistance but is a very thin product. Hope this helps! Thank you, The Henkel Adhesives Team

My bike chainguard rubber armor dropped, used regular double side tape but it also dropped off because of hot weather. Is this 401 works on that ? Rubber chainguard protection into carbon fiber bike frame.

@henkeladhesivesanz

Жыл бұрын

Hi there, Could you please provide us with some more information on your application? - Do you know what type of rubber the chain guard is made off? - Who is the manufacturer? - Do you have any pictures you can share of the chain guard in place? - How was the chain guard originally secured? You can email us through this information at loctite.enquiries@henkel.com and one of our Application Engineers will be happy to assist. Thank you, The Henkel Adhesives Team

@uuryzc

Жыл бұрын

@@henkeladhesivesanz Hi, thank you for response. - it's Zefal chainstay armor - Original one dropped after 3 years of useage, i think they used some kind of glue on it originally (Trek Supercaliber bike) - I have tried to use double sided VHB tape, it hold for some time but when weather get too hot, it also dropped (dropped on chainguard side, it's still sticked to frame)

@henkeladhesivesanz

Жыл бұрын

@@uuryzc The original adhesive was a pressure sensitive type, unfortunately, they do not fully cure but remain tacky, which help for future easy removal but means they are sensitive to softening and moving / sliding with heat over time. This is the trade-off. If you want a more permanent solution than a product that cures is required. This will be a lot more difficult to remove in the future. If that is ok, then have a look at our Loctite Extreme Glue No Drip Gel. www.loctite-consumer.com.au/en/products/loctite-extreme/loctite-extreme-gel.html

@magicsarap1809

Жыл бұрын

Do u have any chemical to remove loctite401

@henkeladhesivesanz

Жыл бұрын

There are a few ways to chemically remove cured 401 and 406. 1. Use Loctite Glue Remover. 2. Use the Clean Up Solvent, Loctite SF 75326 that is found in the Imperial O ring kit, or 3. Use a paint stripper like Loctite SF 790. If you need the Technical Data Sheets for any of these products, please let us know your email address and we can send them your way. Thank you, The Henkel Adhesives Team

Hi, wich Loctite can I use if I will put a screw into a plastic plate to reinforce it?

@henkeladhesivesanz

Жыл бұрын

Hi there, For metal to plastic or plastic to plastic threadlocking, please consider our Loctite 425 low strength threadlocker. Thank you, The Henkel Adhesives Team

@Kimbangucantus

11 ай бұрын

@@henkeladhesivesanz I'm from Belgium and I don't found the 425, Only the 401, 406 or 243. Wich of those 3 is good?

Pls tell me 1 pc price 😊