00:00 Overview of the Leica GS16 and GS18 sensor, which both have internal Satel radios that are 1 wat transmit and receive, thus the unit can be either a Base or RTK rover depending on configuration. In this case will configure as a base using the 1 watt TX radio- range of 1 watt is approx. 1 mile
00:58 Schematic GS18 base sensor and accessories
01:25 Schematic GS16 Base sensor and accessories
01:45 Overview of accessories got GS16 and GS18T base 1 watt
02:30 Antenna for GS16 GAD109 and GAT2 and Mini SD card for Static
03:15 Antenna for GS18t : GAT28
04:00 Enable "Switch to GS base mode" application
04:43 Bluetooth GS16 to cs20 in Base mode
05:30 GPS tracking and cutoff angel settings
05:50 Enable Static Data on Base GS16 -stores to the SD card in Sensor
06:10 Transmit RTK settings via GS radio- using RTCM (MSM) and enable the Satel radio device
07:05 Base ID Settings
07:20 Program radio frequencies and channels provided by FCC- Frequency, Spacing 12.5khz and Data modulation
09:05 Reprogram Channels (frequencies)
09:19 Base setup 3 Methods
1. Any Point- will grab autonomous position +/- 10 feet for local survey
2. Last Point - if setting up next day on same point
3. Known point - if loaded control points to Jobs, ensure correct . coordinate system or can hand type in control point
09:55 Change CS20 from Base mode to Rover mode to hook up to the GS18T rover radio unit \, so one cs20 can setup a Base and then run a rover in field using the base
10:15 Tips for Base station : Overview of front panel Status lights for GS16 and GS18T