Just got mines today lol pretty nice set up so far for a newbie…

Got the same Machine on the way this week. guess we will both be learning lol

Set your gauge to 40 psi and barely crack open your lead torch you'll see the difference

That galvanized metal giving you the headache.

One thing you need to know is wind is a bad thing for tig

hey man im not too sure to be exact but i have a yeswelder aswell and it performs great. but i think that machine only runs DC, meaning it will only do Steal, titanium and other materials. not sure what you where gettin after in the video there couldnt really tell but that machine wont do aluminum

Have you tried switching polarity?

Look up "metal fume fever"

Did you clean the plate with acetone than wire brush it with a stainless brush making you strokes in the same direction and than cleaning it with acetone again. I've watched enough YT videos to know this much. No expert here just asking questions. I'm old I can gas weld arc and mig weld.

The machine you are using will NOT work for aluminum. It should work great for steel though.

What kind of lift cause I’ve been looking into scissors lifts

@GibsonGarage

3 ай бұрын

It's a 9k lb four post lift

is not the machine, its you, that machine only can weld on DC

BEWARE: YesWelder will not service or support anything not purchased through their official YesWelder stores. If you need a part and don't have an approved purchase invoice, they will not support it. No parts are available on their website. THESE ARE DISPOSABLE UNITS.

Your gas is to high it's blowing your weld off that's why it isn't holding

You cant weld aluminum with that machine only carbon an stainless steel an your gas is to high