Lawn Mower User Manual
Тәжірибелік нұсқаулар және стиль
PLEASE ENSURE YOU READ THESE INSTRUCTIONS CAREFULLY FIRST TO ENSURE YOUR SAFETY. IF THE TOOL IS NOT USED AND INSTALLED CORRECTLY ACCORDING TO THE INSTRUCTIONS, IT COULD RESULT IN SERIOUS INJURIES.
0:00 Step 2: Assemble the Big Protection Guard and Wheels.
1:17 Step 3: Install the assembled Big Protection Guard onto the machine.
2:20 Step 4: Install the blade.
3:09 Step 5: Install the handle.
4:36 Step 6: Install the Protection Frame.
5:04 Step 7: Adjust the angle of the lawnmower.
5:19 Step 8: Install the battery and turn on the lawnmower.
5:55 Step 9: change the blade.
10:15 Step 10: Change to the Small Protection Guard.
Пікірлер: 16
this was very helpful, but can you please explain what each of the blades would be used for. thank you
@congeeearl390
22 күн бұрын
Please refer to this link: imgur.com/F06f5MY.
@sandraspear4590
18 күн бұрын
@@congeeearl390
The instructions were very good for assembly. But you should tell us which blades to use for what jobs. Also, when or why to use the smaller protection guard versus the large one with wheels. I'm going to try to find the sales ad on Facebook and see if there are any clues there; I seem to remember lots of demo videos when I bought the machine.
What are the different blades for.
Pls provide information about the use of each blade. It’s really confusing
@congeeearl390
22 күн бұрын
Please refer to this link: imgur.com/F06f5MY.
Está muy corto el video deben de explicar bien cómo usar todas las navajas 😮
How long to charge the battery? How many hours?
What is each blade used for
What each blade use for?
How to charge the battery ? Please help
@congeeearl390
22 күн бұрын
Please refer to this link: imgur.com/DWJmv9K
It is not possible to tighten the screws because there is a blue stop on the nut.
@congeeearl390
22 күн бұрын
Could you please consider using a wrench to tighten the screw? The blue stop on the nut is intended to prevent the screw from falling off automatically.
@HarwinderSingh-fk5vw
10 күн бұрын
It is tightened just hold the screw into the gap at screw point