My biggest takeaway was the "Fill Shapes Individually" option, which I hadn't noticed before. It can be a real time-saver. Thanks!

Great vid! I bought the same boards and never engraved Acacia before, so was sitting here pondering the settings. Thanks for sharing!!

thanks for the video. im local here also in louisville in the prp area.

Nice! I have needed a cheaper way to do exactly what you have done with the cardboard. I have been using a 1/4 plywood running as fast as the laser would go as light as it will go, and just keep reusing it.

Great Explanation!

Brilliant video. Thanks for sharing

Have you done inlays that way ? I tend to use my outline function quite a bit . I thought about using plywood cut outs like your cardboard for coasters and key chains and reuse as needed , I’m sure you do also . Do you use absolute coordinates or origin ? I’m very new to this obviously. What do you prefer mm/m or in/sec or mm/sec or in/min ? I started with mm/m then tried mm/sec big difference on my diode laser , co2 I don’t know !

Do you but your cutting board or make them?

Thank you for the video, you mind telling me where you get your cutting boards from?

@davekimbler2308

Жыл бұрын

Amazon sells them and Etsy also

@kevinlavin6633

Жыл бұрын

I just bought the exact same boards from Hobby Lobby... super inexpensive.

@Heinzskitz14

Жыл бұрын

@@kevinlavin6633 Thanks!

what happend to your aeon? did it burn?

what is the work space of your co2 laser?

Why you don't used autofocus?