Good to see you back again mate. Keep up the content!
@jessebrown904611 ай бұрын
My 05 HSE won't move in drive at all but did in reverse barely, its not low on fluid, the drive shafts don't move in gear and if you give it gas the rpm drops and almost stalls for a sec
@Spidercarfix3 жыл бұрын
Greetings, I would like to know if i can swap it to a td27tdi engine and keep the auto transmission of the range rover. Let me know, thanks!!
@Farmer24926 ай бұрын
Hi great video i just brought a 2002 landrover discovery td5 with a crook auto gearbox the owner took it to a gearbox place they said the the trigger wheel sensor was off center trigger wheel was found to be very loose and can move back and fourth 10mm would that cause it to only have first gear and reverse ive been told its a common problem the bolt comes loose
@ourme23 жыл бұрын
Great video, Thanks for your insight! What did you do to ensure the shaved spline metal shards won't damage something else in the trans? where did they go?
@TattyCarTravels-VW
3 жыл бұрын
They’re a few bits (not much) on the drain plug (magnetic) I ran some fluid through and replaced the filter.. hopefully that got some of it..
@elliot3302 жыл бұрын
Brilliant video an just the right time for me. I have the 300tdi auto D1. The front propshaft decided to let go and crack the gearbox. So I have several questions for you...
@solantar6912
2 жыл бұрын
may i ask what auto box you used i see its the d1 , i know Ashcroft have a zf4hp22 wondering if it can handle twice the torque of the original 300tdi defender , any info , many thanks
@JonDingle3 жыл бұрын
Top buy and repair young man! You could sell it on, do a give away or raffle it somehow?
@meganswanson50302 жыл бұрын
looking for conversion kit for 300tdi
@feronikanua6096 Жыл бұрын
Good video mate keep it up
@graham-martin58473 жыл бұрын
quick question ive had same issue how do you get the torque converter to line up with the four bolts on the flywheel as i cant figure it out and only way you can see what your doing is to take the sump off which is what i am doing tomorrow any help would be apreciated
@TattyCarTravels-VW
3 жыл бұрын
I put my phone down where the starter motor was.. had it in film mode and spun it around (torque converter) until a hole lined up.. one on is in its bloody easy.. but that first one 😭
@graham-martin5847
3 жыл бұрын
@@TattyCarTravels-VW ok cheers i was gonna take starter motor off to check to see if i could do it that way ,just had to put oil pump in as broke first one by slapping the box and engine toget the incorrect way derr what i am
@x5or2 жыл бұрын
This chicken reminds me of a tasty meal after a good fight with this transmission.
@bubblez9104 Жыл бұрын
Mine is going into reverse. But doesn’t make any sound when i go to any other gear. Doesn’t sound like it’s engaging or doing anything other than in reverse. Other than when i go to park it makes a grinding noise.
@bubblez9104
Жыл бұрын
I got told transmission by one guy. Another said it may be the shift silenoids
@griffindeluce2 жыл бұрын
He dumped some of the liquid from the torque converter into that bucket. ?
@Lifeofmike893 жыл бұрын
Mine has just done the same looks like I no what's gone now
@mikeboyse25663 жыл бұрын
We want to see the disco go!
@TattyCarTravels-VW
3 жыл бұрын
When you say go.... you mean drive? 😜
@mikeboyse2566
3 жыл бұрын
@@TattyCarTravels-VW oh, of course!! Drive just didn't rhyme.. Quite like a disco to be honest...
@markthompson11343 жыл бұрын
i have a discovery 3 and autumatic it drives for 30 minutes then stops you have to wait till it goes cold and then you can drive it
@TwistedOwen
3 жыл бұрын
Maybe Torque Converter, I know 3 months hope you figured it out
@josearoca403 жыл бұрын
help me? FLEXPLATE LAND ROVER DISCOVERY 1 AUTOMATIC
@TattyCarTravels-VW
3 жыл бұрын
You in need of one?
@josearoca40
3 жыл бұрын
@@TattyCarTravels-VW Thank you for answering so quickly. I would like to know how to disassemble and then reassemble the automatic Land Rover Discovery 1 FlexPlate, and to know where I can purchase the necessary parts to replace it.
@TattyCarTravels-VW
3 жыл бұрын
Owners manual is the best option, you’ll either need to remove the engine or box to get access, it’s bolted to the flywheel and the torque converter bolts through it (4 small bolts) I’ve got a flex plate and a automatic box in the barn as I only needed the torque converter to fix the truck 😃
@ezzideen81tarrani643 жыл бұрын
Hi , my friend If you like to buy your car pls, tell me
Пікірлер: 31
Good to see you back again mate. Keep up the content!
My 05 HSE won't move in drive at all but did in reverse barely, its not low on fluid, the drive shafts don't move in gear and if you give it gas the rpm drops and almost stalls for a sec
Greetings, I would like to know if i can swap it to a td27tdi engine and keep the auto transmission of the range rover. Let me know, thanks!!
Hi great video i just brought a 2002 landrover discovery td5 with a crook auto gearbox the owner took it to a gearbox place they said the the trigger wheel sensor was off center trigger wheel was found to be very loose and can move back and fourth 10mm would that cause it to only have first gear and reverse ive been told its a common problem the bolt comes loose
Great video, Thanks for your insight! What did you do to ensure the shaved spline metal shards won't damage something else in the trans? where did they go?
@TattyCarTravels-VW
3 жыл бұрын
They’re a few bits (not much) on the drain plug (magnetic) I ran some fluid through and replaced the filter.. hopefully that got some of it..
Brilliant video an just the right time for me. I have the 300tdi auto D1. The front propshaft decided to let go and crack the gearbox. So I have several questions for you...
@solantar6912
2 жыл бұрын
may i ask what auto box you used i see its the d1 , i know Ashcroft have a zf4hp22 wondering if it can handle twice the torque of the original 300tdi defender , any info , many thanks
Top buy and repair young man! You could sell it on, do a give away or raffle it somehow?
looking for conversion kit for 300tdi
Good video mate keep it up
quick question ive had same issue how do you get the torque converter to line up with the four bolts on the flywheel as i cant figure it out and only way you can see what your doing is to take the sump off which is what i am doing tomorrow any help would be apreciated
@TattyCarTravels-VW
3 жыл бұрын
I put my phone down where the starter motor was.. had it in film mode and spun it around (torque converter) until a hole lined up.. one on is in its bloody easy.. but that first one 😭
@graham-martin5847
3 жыл бұрын
@@TattyCarTravels-VW ok cheers i was gonna take starter motor off to check to see if i could do it that way ,just had to put oil pump in as broke first one by slapping the box and engine toget the incorrect way derr what i am
This chicken reminds me of a tasty meal after a good fight with this transmission.
Mine is going into reverse. But doesn’t make any sound when i go to any other gear. Doesn’t sound like it’s engaging or doing anything other than in reverse. Other than when i go to park it makes a grinding noise.
@bubblez9104
Жыл бұрын
I got told transmission by one guy. Another said it may be the shift silenoids
He dumped some of the liquid from the torque converter into that bucket. ?
Mine has just done the same looks like I no what's gone now
We want to see the disco go!
@TattyCarTravels-VW
3 жыл бұрын
When you say go.... you mean drive? 😜
@mikeboyse2566
3 жыл бұрын
@@TattyCarTravels-VW oh, of course!! Drive just didn't rhyme.. Quite like a disco to be honest...
i have a discovery 3 and autumatic it drives for 30 minutes then stops you have to wait till it goes cold and then you can drive it
@TwistedOwen
3 жыл бұрын
Maybe Torque Converter, I know 3 months hope you figured it out
help me? FLEXPLATE LAND ROVER DISCOVERY 1 AUTOMATIC
@TattyCarTravels-VW
3 жыл бұрын
You in need of one?
@josearoca40
3 жыл бұрын
@@TattyCarTravels-VW Thank you for answering so quickly. I would like to know how to disassemble and then reassemble the automatic Land Rover Discovery 1 FlexPlate, and to know where I can purchase the necessary parts to replace it.
@TattyCarTravels-VW
3 жыл бұрын
Owners manual is the best option, you’ll either need to remove the engine or box to get access, it’s bolted to the flywheel and the torque converter bolts through it (4 small bolts) I’ve got a flex plate and a automatic box in the barn as I only needed the torque converter to fix the truck 😃
Hi , my friend If you like to buy your car pls, tell me
🐓🤣
🐓🐓🐓🐓