KENMORE 600 SERIES WASHER HOW TO CALIBRATE RECALIBRATE STEP-BY-STEP INSTRUCTIONS SERVICE CALIBRATION
CORRECTION !!!!!!!!!!!!! IN THE VIDEO I TELL YOU TO SELECT CYCLE SIGNAL FOR CALIBRATION THAT IS NOT CORRECT YOU SHOULD SELECT SPIN SPEED FOR CALIBRATION AFTER YOU COMPLETE THE 1-2-3 CYCLE.
PLEASE DONATE TO HELP FUTURE PRODUCTION OF OTHER VIDEOS TO COME paypal.me/appl...
Welcome to APPLIANCE FLIPPER 8590Your Ultimate Guide to Home Appliance Mastery!
THIS IS A 052 RUN SERVICE CALIBRATION
Explore the world of efficient home management with our expert tutorials and step-by-step guides. On this channel, we specialize in unlocking the full potential of your household appliances, and our latest series is all about the Kenmore 600 Series Washer.
In this dedicated playlist, we break down the calibration and recalibration process of the Kenmore 600 Series Washer with detailed step-by-step instructions. Whether you're a seasoned DIY enthusiast or a first-time homeowner, we've got you covered. Our goal is to empower you with the knowledge and skills to optimize the performance of your washer and elevate your laundry experience.
Join our community of home enthusiasts as we dive into the intricacies of appliance maintenance, troubleshooting, and upgrades. Subscribe now and never miss a beat - your laundry routine is about to reach a whole new level of efficiency!
Don't forget to hit the notification bell to stay updated on the latest tips and tricks for your Kenmore 600 Series Washer. Let's make every cycle count - welcome to APPLIANCE FLIPPER 8590, where home appliances meet expertise!
Пікірлер: 15
Thank You, I don't have any instructions on how this works. I just got it yesterday for free. When I put my first load in it won't drain out so I recalibrated it it's washing again I hope I can get it to rinse and drain also. Thank You, I appreciate you.❤
Thank you so much...❤ single mom!!!
Do you have a video on replacing the suspension rods? My machine keeps going off balance and the spin cycle shakes really hard sometimes
I just did this and it took longer than 5-7 minutes. Almost freaked out. Maybe mine needed to be calibrated more? It took a good 10 -13 minutes. Thank you for sharing!
@lastnole76
2 ай бұрын
If u don't mind me asking, what was the issue you had with your washer??
❤thank you very much
How do I get it out of diagnostic mode?
As so as I press the start button after I put 052…it shuts down leaving the power lite on n start lite on n it locks…nothing happens
Hello I have the same washer as Kenmore 600 it will not fill up with water how do we no if the water pump I bought it at a yard sale wasted my money but can you help me please 🥺
@applianceflipper8590
2 ай бұрын
No water at all or just a low fill?
@donnabigleggins1928
2 ай бұрын
@@applianceflipper8590 yes no water
@donnabigleggins1928
2 ай бұрын
@@applianceflipper8590 and I tried to get it to fill up but nothing the hot and cold is on but won't run in washer should I just trash it I should have tested before I bought it 😕
@dianacardenas4953
Ай бұрын
@@applianceflipper8590 mine is doing the same just a little bit of water comes out doesn’t even fill half way. What would you suggest ?
Stays at 000 when turning the knob. 🤷🏻♂️
@Maccam113
24 күн бұрын
Gotta keep turning, mine wouldn't budge till I kept spinning