Just Put Shaving Blade on the Led Bulb and you will be amazed! Master Handyman wisdom
Here is easy way to fix your broken led bulb at home without soldering iron , All you need is just a shaving blade and some tape. just remove the broken led on the circuit and replace them with small cut pieces of shaving blade. Hope you like our content! Subscribe to our channel it helps a lot.
🔴Please do not try this at home; it is simply an experiment.
#ledlights #inventions #repair
DRWOW
#led #hack #amazing #science
Пікірлер: 28
I'm amazed on how stupid this was
And now the remaining LEDs won't last 24 hours.
@NasM
26 күн бұрын
Unless the resistance of the shaving blade is precisely calculated to match the missing LED ;) LOL ...
@mbunds
16 күн бұрын
@@NasM I have to source precision-calibrated razor blades somewhere...
congratulations. Today youy learned how to complete a circuit.
@FrankyFixIt
26 күн бұрын
Now the rest of leds burn out ten times faster do to higher voltage divided across fewer LEDs 🤣🤣🤣
This is some dumb shit. He had a razor knife to strip the wire too, but decided to melt the insulation to make toxic smoke instead. Master Handyman???
@johnroberts3824
26 күн бұрын
Not to mention that it's not really worth it to repair one of those bulbs. Just toss it.
Another irresponsible video trying to get someone electrocuted. Ever hear of wire strippers?
Maybe just buy a new bulb they are cheap
Nope. Don't ever do this.
The two diodes failed because they were already strained beyond their specifications. LED bulb makers do that so that they will burn out sooner than 10 years. This "fix" strains the remaining LEDs even harder, which only means they will burn out faster.
@barongerhardt
27 күн бұрын
Yes, please use a multi meter-detect the bad LEDs, get the resistance of a good one, and circuit voltage. Then replace with a comparable LED, diode, or resistor; using a soldering iron. If the circuit is over driving the LEDs add a resistor to bring things in spec.
inspiring content
I've got a much better life hack - report this video so no one gets electrocuted or has their house burned down.
Scocket popping u can also use lead like from pencil wrap it w toilet paper n boom u light u rollie
Then after a few minutes the rest of the LED's burn because missing the other 2, the voltage will be too high.
I reported it. Don't do this, kids.
So when did your House burn down anyways?
Tho it works the risk of fire increases
Isn't it easier just to buy a new bulb?
Is this art?
This is bonkers. Flammable material next to a poor electrical join with high voltage, followed up with an uncontrolled high voltage electrolysis reaction with lots of bare wires. What could possibly go wrong?
It will fail shortly after.
Dangerous. Don't do this.
Yea, don't do this.
jfc. what?