This was great mate, keep it up!!! Enjoyed the little parts with the gauge and sensor's and the waste gate spring too

@house-ofhoon

2 жыл бұрын

Cheers mate! Glad you enjoyed those parts 😁

Glad I'm not alone in thinking the JRP gauge is incredibly similar to the Defi copies doing the rounds...

@house-ofhoon

Жыл бұрын

Definitely similar. Some good improvements on the JRP though and better quality

Yeah buddy, clever move with the air intake temp! Keep it up 😀

@house-ofhoon

2 жыл бұрын

Cheers mate! The AIT sensor is definitely coming in handy 😁

Good stuff like to see the numbers after Dyno. Have fun

@house-ofhoon

2 жыл бұрын

Cheers mate! There will be a video of the dyno coming soon!

Very helpful cheers

@house-ofhoon

Жыл бұрын

Glad you liked it mate!

Enjoyed the vid. :)

@house-ofhoon

2 жыл бұрын

Cheers James!

Another awesome build mate, a few ripper quotes *the speed of 1000 gazels* 😂. I have a multiguage ready to hook up also so this was relevant to me Did you make your red steps and scrub bars? They look awesome 😎

@house-ofhoon

2 жыл бұрын

Haha cheers mate! Picked that one up from the Army lol. Yep, I sure did make the sliders and brush bars, thanks man 🙂 Best of luck with your multigauge install! 🤙

Great vid, got a JRP unit myself and cant fault it! Did you end up swapping the AIT to both sides of the intercooler to see the temperature difference?

@house-ofhoon

2 жыл бұрын

Cheers mate! No, I ran out of time. I'm planning on doing a video comparing the two though 😊

0:44 Mmm, I wonder what happens next. So it sounds like the JRP kit is a definite upgrade over the defi knockoff? I mean, the defi clone is pretty cheap, so I can understand why the cables, wires, and sensors are not as good.

@house-ofhoon

9 ай бұрын

Yep the JRP kit is definitely a good kit and an upgrade over the defi clone 👍

What is that contraption your winch is hooked into on your bullbar? Thanks mate great video

@house-ofhoon

2 жыл бұрын

Cheers mate. It's my first attempt at a 3D printed winch dildo to suit my specific application. I need to print a V2

29psi is a bit high haha. I run less then 20 with a 250hp 12mm pump

@house-ofhoon

2 жыл бұрын

Haha yea the tuner turned it down to 23psi 👌

@donaldwills2135

2 жыл бұрын

@@house-ofhoon what did she make

@house-ofhoon

2 жыл бұрын

Trying to keep it hush hush at the moment until the video comes out sorry. But it's a healthy number considering its still got the factory pump

@donaldwills2135

2 жыл бұрын

@@house-ofhoon thought as much I'll keep a eye on posts

@Berawabilly

2 жыл бұрын

I run 32psi with a ufi 250hp pump. how much power you making?

get a 12mm bruh

@house-ofhoon

2 жыл бұрын

Are you going to pay for it bruh?