Rube Goldberg: The Master of Absurd Machines Rube Goldberg was a cartoonist who drew absurd machines that performed simple tasks in complicated ways LIVES ON in JEEP engineering.

I swear i couldnt ask for a more detailed video. this was perfect. I just got some rusted dorrs with problems since brand new ones cost hundreds, and these ones off face book marketplace i got for $80. need paint, but the internals needed to be oiled but I didnt know how to open them. thank you

After my 92 YJ driver side exterior door handle broke I found several videos but yours had the most detail. Thanks for taking the time to make it - I was able to replace mine today.

@offthejeepend178

3 жыл бұрын

Thank you! Means a lot!

Thanks for the video, great detail. A tip for anyone doing this, the sawtooth pieces are setup to be inserted/removed from the top. There is very little room to do this inside the door and it is very difficult to do on some models. Before you put the new handle in the door, remove the metal clip that engages the teeth on the sawtooth bracket, and flip them around 180 degrees, so they are upside down. NO tools needed for this, easy to do with fingers. This will allow the sawtooth brackets to install bottom-up, when in the door. There is much more room to access this way and makes the job much easier.

FYI to other YJ folks - the NAPA brand replacement interior handles hold up well. You can order them online and they come with the appropriate clips to lock the rods in. The clips that come with the new handle are not the same ones that come in the repair pack of clips. The ones on the handle are better by far and hold up quite well. The new interior handle will also make your now over 27 year old YJ look fancy.

Great video. A lot of attention to detail plus good advise. Thanks!

Did this last week before finding your channel. Was pretty easy. Can't believe what jeep wanted for new door handle. Mine was worn in the driver's side and the lever would slide past the latch rod. Repaired rather than replaced and working great now. Would love to see something on suspension like leaf spring replacement.

Thanks for the video!

I liked your video what was the link for the speciality tool with clips. Thanks for making the video.

Where you bought the parts from ?

@offthejeepend178

3 жыл бұрын

Quadratec or amazon

@jmarceth5

3 жыл бұрын

@@offthejeepend178 do you have the part number , my door sometime doesn’t wants to open ,

@offthejeepend178

3 жыл бұрын

I don't have it but I'm sure on quadratec it can easily be found

@jmarceth5

3 жыл бұрын

@@offthejeepend178 thank you

Most people upload videos of their door handle being stuck, but able to open the door... so, "easy". Mine is stuck but is closed.... the "clamp", don't now the exact name, doesn't open. Help!

@offthejeepend178

3 жыл бұрын

The rod in your door might be not not connected or seized. Go in the jeep, pry the interior plastics off, and move one of the rods to unlock the door and with the door open remove the parts and see what isn't able to move

@78tag

Жыл бұрын

@@offthejeepend178 I think what he was telling (which is my problem now) the door can't be opened. Need to get door panel off. Can't get panel off. Can't use special tool to get to fasteners - can't get to "interior plastic" to look at lock.