No video
Jeep WJ 4.0 Valve Cover Gasket Replacement
Replacing the Valve Cover Gasket on a Jeep WJ 4.0
This video demonstrates how to replace the Valve Cover Gasket on a 2001 Jeep Grand Cherokee Laredo with the 4.0 straight six engine. The process is similar for all vehicles equipped with Jeep’s 4.0 L (242 CI) inline six cylinder engine.
Пікірлер: 18
Thank you for the video! Mine had a big leak all around to the point of smoking. This guide will be very useful!
@TheHappyLife-h7b
Жыл бұрын
Thanks for watching!
Appreciate the video, thank you!
@TheHappyLife-h7b
8 ай бұрын
Thanks for watching!!
The hard one in the back.What size socket do you use?
@TheHappyLife-h7b
Ай бұрын
Thanks for watching! I think it was a 10mm but I can check again.
How much you torque them down for ?
@TheHappyLife-h7b
Жыл бұрын
The owners manual gave the torque in Inch Pounds. I used 10 Foot Pounds as that was as low as my Torque wrench would go. Thanks for watching!
@brandoncondatore1051
Жыл бұрын
@@TheHappyLife-h7b inch-lbs are alot less of I'm not mistaken. Does it leak at all?
Will this work for my 03 Jeep Cherokee?
@TheHappyLife-h7b
Жыл бұрын
It should work on all WJ Jeeps with the 4.0 inline 6 cylinder engine. Thanks for watching.
what are the torque number for it you need to provide that bruhhhh
@TheHappyLife-h7b
6 ай бұрын
85 inch pounds or approximately 7 ft lbs of torque. The lowest I can go on my torque wrench is 10 ft lbs. Thanks for watching.
If it is leaking can it make your car run hot
@TheHappyLife-h7b
2 жыл бұрын
The vehicle actually runs better now that it has been replaced.
@emilymarie4497
Жыл бұрын
With my car it hasn't been running hot but the oil pressure gauge has been high. I don't idle for a really long time in my car so I can't tell for sure if it's running hot.
Trini or Guyanese 😂
@TheHappyLife-h7b
4 ай бұрын
Trini