Installing new bearings in a chainsaw crank case
Another repair that is rather difficult to video. There is no graceful way to assembly a crank case and doing on camera, in a position that can be viewed, makes it more difficult. This is another at home method. Using tools most anyone has.
Пікірлер: 24
I’m so glad you’re back to making your videos again. You are my favorite! You don’t have a continual barrage obnoxious bs just good instructional content. Thank you, sir!
That certainly fought you pretty good. Great job though. Love these videos of yours
nice one...i put the block on electric panel for cooking block position it crank side down...and then just put the whole crankshaft with bearing inside...i heat the other half and just put it togheter... piece of cake :D sory for my bad english...greets from Slovenia
Thanks for sharing! When my cranckshaft is not rotating easily I heat the place for the bearing again and hit this place with a metal extension and plastic hammer. So the bearing will be free of tension. I never hit the cranckshaft because I think is wil damage hte bearing. But I can be totally wrong. I only got the result online here on KZread. greets from Holland.
nicely done.
I drilled a hole in a piece of 4 by 4 and I use it to put the crank in when I put the cases together. I just put the end of the crank down to the counterweights after it comes from the freezer at about 2-4 degrees and grab the crankcase half out of the stove at about 260 degrees and push it on the crank. It usually goes on without a lot of pushing. I then put the crank/ case half in the freezer and put the other half in the oven. The second half usually goes on with a little more effort. Sometimes I use the screws to pull it on down but not always.
map gas makes things much quicker. awsome video
how far in do you set the shaft seals?
Do you use locktite on the bolts?
Hey. Thanks for the video. I'm rebuilding a Husqvarna 61. I'm putting in all new bearings, seals and crank shaft in it. I'm just wondering if I should grease the bearings? Any help or suggestions would be great. This is my first time doing this. Thanks. Michael
@darthtrump4428
4 жыл бұрын
no, perhaps lube them a bit with 2stroke oil after instalation why are you replacing crankshaft
Evening Friend, how long do you keep the bearings in the oven. Can it damage them if left too long? Adam, glasgow
Thanks for showing your method, I’ll make sure I use one of the other methods since this one seems a bit forced and clumsy.
Awesome :)
They offer a puller to pull the crank into the case.
how to replace stihl chainsaw bar mounting studs ms290
@mweba1
10 жыл бұрын
Procedure can be found in this video I shot. kzread.info/dash/bejne/mIl5y7qGqtO-hNY.html
@johnnyvorschilde2346
9 жыл бұрын
+oren levy If it's like a 250 you get to rebuild the whole thing, as the bar studs are integral to the gas tank/ crankcase core piece.
how do you know that the bearings are bad?
@darthtrump4428
4 жыл бұрын
they have axial and radial play in em
Flush with the case
I can't use the torch...I will melt down the crankcase...it's plastic 🙂
Sorry, not directed at you.