Installing handlebars, hand guards, and mirrors on my 2022 Honda CRF300L
Автокөліктер мен көлік құралдары
Support my channel on Patreon! www.patreon.com/labcoatpaul?f...
Renthal Ricky Carmichael handlebars: www.rockymountainatvmc.com/pa...
Tusk D-flext pro adventure hand guards: www.rockymountainatvmc.com/pa...
Double Take adventure mirror kit LEFT: www.rockymountainatvmc.com/pa...
Double Take adventure mirror kit RIGHT: www.rockymountainatvmc.com/pa...
Tusk grip end cutter set: www.rockymountainatvmc.com/pa...
0:00 introduction
0:26 removing old mirrors
0:36 remove clutch lever
0:45 remove left switch
1:05 remove front brake lever
1:12 remove right switch
1:26 remove old handlebars
1:46 Renthal bars at rocky mountain ATV/MC
2:02 handlebar weight old vs new
2:31 installing new handlebars
2:51 torque clamps to 20ft-lb or 27n-M
3:00 remove throttle tube
3:07 disconnect throttle cable
3:16 the wrong grips online
3:29 throttle cams
3:54 drilling out ends of grips
4:08 installing new grips
4:22 connect throttle cable
4:42 install right side switch
4:51 install levers
5:26 adjust controls on bars
5:55 move brake hose
6:03 installing Tusk hand guards
6:56 bending hand guards
7:05 brake hose clearance
7:42 brake hose blocks speedometer fix
8:18 drilling into the bar
9:28 why the new grips don't fit
10:08 hand guard turns signals
10:43 installing double take mirrors
11:39 conclusion
Пікірлер: 15
I just spent too much time trying to install the same odi grips as well. Thank you for confirming my hunch they wouldn’t work.
Thankfully watched your video before ordering ODI grips
Never been so early, don't have time to watch this video but thank you for every tutorial and guide you have uploaded. Greetings from Iceland.
@LabCoatPaul
2 жыл бұрын
That's awesome! Thanks for watching!
Haha love your dry humor man! Got the same hand guards as your but I’m using the lights as safety is not as important as looking cool 😎
Thanks for the video, I was about to buy the same grips for my 300L but now I know better thanks to it.
Very detailed video! Thank you. I am shopping for new handlebars for my crf.
Awesome
Steel screws on aluminum thread, Loctite is not needed, they already block by themselves, copper grease is needed, in my opinion. 🤔
Lol. A smart person would loosen the throttle linkage.....hindsight is educational. I did something similar on my 50, same issues. You can use some aluminum brazing rods to fill that hole and try again.
@LabCoatPaul
2 жыл бұрын
Those rods might be a good idea. I've never tried that!
Love all your vids even though I don't own a RAV4 or a CRF300L! Always entertaining and always impressed with your ingenuity. Watched this one a few days ago then was thinking back to the video of yours I saw where you installed Highway Dirt Bike guards on your KTM. So this of course got me to thinking: why did you not go for the HDB's this time?
@LabCoatPaul
2 жыл бұрын
I think the HDB hand guards are better, but they don't sell the integrated bar clamp for my Honda.
I’m assuming 3/16” hole was too big for the dowel?
This seems like a royal pain in the ass