Thanks for giving the full list of elements this is exactly what I was looking for and it is great. So helpful!

Looks great, thanks for the detail instructions

Exactly what i was looking for 🙌🏻 thanks for sharing 😊

@porcelanaboy

3 ай бұрын

😊😊😊😊😊😊😊😊😊😊😊😊😊

Good work 💪

This is awesome! My island is almost exactly like yours, so i’m simply following this step by step😂 a question regarding the power socket though. Is it simply a cut through and then placed over the socket or did you extend the socket somehow to make it line up so perfectly through the hole?

This is really clear and helpful. Thank you, I am just about to build something like this. However, I have one question. Is there an alternative to fixing it to the floor? I would like to avoid drilling into the floor. My unit will be a little large and include a narrow wine fridge. I wonder whether the weight is sufficient to keep it stable. I would be grateful of any thoughts. Thanks.

@malaymartian9688

Жыл бұрын

I have the same questionn!

This looks like exactly what I need to finish my kitchen. Where did you get the worktop and what size is it? Also, I assume you just used decorators filler for the holes in the open cabinet?

@simplehomediy8888

3 жыл бұрын

For the holes i used these cover caps from Ikea: www.ikea.com/gb/en/p/variera-cover-cap-white-00226315/ Worktop i got from a local shop, cut to order. Size is 44 by 144 cm (about 17 by 57 inches)

How did you saw the back cover panels to 80x80cm to match one metod? (cause the size at ikea are never 80cm?) thx for the video!

@simplehomediy8888

3 жыл бұрын

I used 2 metod cabinets, one 60cm wide and one 80cm wide. For the cover panels i used 3 61.5x80cm panels, 2 full lenght ones side by side (didnt have to cut them at all) and narrow strip from the third one against the wall.

How is the kitchen island confirmed to the wall?

The small last piece you used as backpanel. Did you cut that your self and from what? Thanks.

@simplehomediy8888

3 жыл бұрын

Yes i cut that myself from the FÖRBÄTTRA cover panel (Article number 402.978.86).

@victornhr7126

3 жыл бұрын

@@simplehomediy8888 Thank you :-)

So the wooden part of the support bracket (5:31) doesn't touch the floor? Ohh I was wondering why its height was lower than the minimum height of the legs.

@thezfunk

Жыл бұрын

The angle brackets hold it to the floor. Once the wooden block it is loosely screwed to the angle bracket, you slide it up to meet the bottom of the cabinet base and then tighten up the screws. This allows you to screw through the cabinet base into the wooden block.

I like you ♥

I subscribe you channel

Great inspiration, thanks for this video. Only wee bit of criticism - there's no way of drilling holes in the floor of a rented place. I'd have put the cabinets on wheels with stoppers instead.