I rebuilt an engine! And it didn't go to plan! - Rebuilding a crash damaged Yamaha YZF R125 | Part 2
In this video we finally get around to taking a look inside the engine of the written off Yamaha YZF R125.
If you recall in Part 1, the engine had a horrible ticking sound. Which is probably just the valve clearances, but I wanted to get a closer look inside to make sue everything is just as it should be. But these things don't always go according to plan, do they?
Пікірлер: 17
Only just discovered your channel, keep the bike rebuild vids going! Absolutely love it, it’s refreshing from seeing car rebuild videos all the time, love the content man !!
@StokedBuilds
2 ай бұрын
Thank you so much! I have been very slow over the last couple of months due to a terrible, cold and wet UK Winter and Spring! However, I am back in the garage and should have this project completed soon! New video incoming in 10, 9, 8, 7.....
Keep it up brother 🔥🔥
@StokedBuilds
Жыл бұрын
Thank you!
That stator cover went on quite easy. I needed to insert threaded rod in block and use as guide to stop magnet from pulling cover off center. New subscriber based on BikerStuff recommendation, great channel.
@StokedBuilds
5 ай бұрын
Haha.. Yeah. In this case it did. Fiddly little buggers aren't they? It might also have been clever editing! I do try to show my mistakes and all. Too many KZread videos make things look dead easy and then when you try they are a right faff.
Probably want a mask with all that degreaser around mate ;-) Nice work Mark - so talented!
@StokedBuilds
Жыл бұрын
Yeah!! The morning "hangover" wasn't so pleasant!
Good work! Can i make a suggestion though, could you turn the music volume down. Constantly having to turn my speaker volume up and down from when the musics playing to when your talking is a bit of a pain lol. Like i said though good work and look forward to the next one 👌
@StokedBuilds
Жыл бұрын
Thanks for the suggestion and feedback. I'm new to this! I'll absolutely make sure I normalise the volume in future videos. Appreciate the feedback.
I need to replace my camshaft and I can’t find any video for it for this engine please help
what valves open first from top dead centre on them engines thanks
@drost582
7 ай бұрын
The next order operation would make intake valve to open.
Where can I get help to rebuild mine and how much did it cost list of tools needed?
@StokedBuilds
3 ай бұрын
Thanks for your comment. I can only suggest watching plenty of KZread videos and buying the workshop manual. The manual is your bible and the KZread videos help you visualise what each step should look like. Hard to say the cost of tools. I have just been building them up over time. But you don't need to start with the best and most expensive of everything. Buy a cheap(ish) set of basic tools and then upgrade them over time.
You got a discord? Just bought a 2012 YZF R125 and it's a non runner, wanted to ask some questions!
@StokedBuilds
5 ай бұрын
I do. Come say hello and if I can help, I will. discord.gg/RdJqGNb4