Hard to have donor boards if you keep fixing them 🤣. Nice video, great work.

Good job. I did notice while watching the loose pin and I said probably no picture. You corrected the easy made mistake which have done too before. All good in the end.

Good job .. tks for share

Great work! Just subbed

Sad XBox ( but cool repair!

First! 😂👌 Nice job! Did you have a pinout of where pin 15 went? Just curious is all.

@tvpartsworld806

Жыл бұрын

It went to the r19 resistor on the other side of the board.

Very good! What is this red brush that you used to remove oxidation from the components?

@tvpartsworld806

Жыл бұрын

Thanks. It’s a fibre pen. I really recommend this pen as it helped me many times. www.ebay.co.uk/itm/111741724919?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=DzEeh3cqQ76&sssrc=2349624&ssuid=4NSEmW3MRyC&var=&widget_ver=artemis&media=COPY

Just curious, what gauge wire are you using for those jumpers?

after fixing a console you bought as broken, do you offer it back to the seller?

what kind of jumper wire are you using I always seem to buy wire that is too thick and the best is copper like the one you are using.

@tvpartsworld806

Жыл бұрын

Hi. Here is a link for it www.ebay.co.uk/itm/185192402954 . This wire is coated with transparent paint so no risk of shorting other components.

@mm0077

Жыл бұрын

@Trilex Fix I use 0.10mm enamelled copper wire or those tiny Bst copper lugs, which all can be bought on amazone, fleebay and Alpress. The Cod3r gets those enamelled wire from old microwave transformer I think.

@trilexfix

Жыл бұрын

@@mm0077 I use the best solder lugs too but sometimes I want a good jumper wire too for those sticky spots

@RBKing80

Жыл бұрын

Why does it matter what wire he uses ? You fake all of your "Repair" videos anyway you utter clown.