First run giving you problems? Check out this informative video! Andrew takes you through the basics of starting, tuning and trouble shooting your Baja 5B. www.hpiracing.com/kits/movies....
Жүктеу.....
Пікірлер: 11
@faxxzc14 жыл бұрын
VERY informative! five stars!!
@sergeantlimpdk72455 жыл бұрын
Great vid mate
@greendemon702 жыл бұрын
Do you ever have to adjust the idle screw or is that done by the low end needle? Thanks
@richardmiddleton7770
Жыл бұрын
Adjust the idle screw for the lowest possible idle then use the trim on your transmitter to adjust the idle. Also the low end mixture screw also affects the whole rpm range so when fine tuning the low end you may have to retune the high end.
@nitroneal482 жыл бұрын
And make sure your kill switch button is not stuck in, mine was and it wouldn't start , I found it when was checking for spark, it runs now
@thecandyman78555 жыл бұрын
I can get mine to back fire but it won't start anyone have any advice?
@Chuckseese
4 жыл бұрын
Screw both high and low set screws in and pull them 1 1/2 turns out and start there
@l4ncer2005
Жыл бұрын
But some gas on the piston little drops and buy new spark plug
@richardmiddleton7770
Жыл бұрын
Richen the low end slightly, make sure the choke can close fully and check the plug isn't fouled up and you have the correct gap set (0.5 - 0.6mm).
@TheInvisibleOrange26 Жыл бұрын
Don’t recommend tuneing it just leave as is unless you want a couple extra MPH or the conditions require
Пікірлер: 11
VERY informative! five stars!!
Great vid mate
Do you ever have to adjust the idle screw or is that done by the low end needle? Thanks
@richardmiddleton7770
Жыл бұрын
Adjust the idle screw for the lowest possible idle then use the trim on your transmitter to adjust the idle. Also the low end mixture screw also affects the whole rpm range so when fine tuning the low end you may have to retune the high end.
And make sure your kill switch button is not stuck in, mine was and it wouldn't start , I found it when was checking for spark, it runs now
I can get mine to back fire but it won't start anyone have any advice?
@Chuckseese
4 жыл бұрын
Screw both high and low set screws in and pull them 1 1/2 turns out and start there
@l4ncer2005
Жыл бұрын
But some gas on the piston little drops and buy new spark plug
@richardmiddleton7770
Жыл бұрын
Richen the low end slightly, make sure the choke can close fully and check the plug isn't fouled up and you have the correct gap set (0.5 - 0.6mm).
Don’t recommend tuneing it just leave as is unless you want a couple extra MPH or the conditions require
Horrible tune