No video
How to use a RELAY with ESP32 | Easy Guide
Affiliate Link for
ESP32:- dir.indiamart....
Additional Board Link
raw.githubuser...
Code and Circuit Diagram
github.com/INO...
For any business queries contact us at inovatrixhelp@gmail.com
Affiliate Link for
ESP32:- dir.indiamart....
Additional Board Link
raw.githubuser...
Code and Circuit Diagram
github.com/INO...
For any business queries contact us at inovatrixhelp@gmail.com
Пікірлер: 29
Please everyone note that Only relay with optocoupler works well in ESP32 The configuration of relay without optocoupler won't work in ESP32 due to direct grounding in relay module
Interesting but a few questions if you can answer please. 1. How many relays can you control? Relays to open close a solenoid coil actuator. 2. To make use in a practical application such as an ESP32 camera installed, detecting an apple. If it's in center of picture open door_center. If it's to the right, open_door right. If it's to the left open door_left If you can help out, otherwise thanks, still an interesting short video.
Mine is switching only once , that too before uploading completely, how to fix?
makasih bang
what is the wiring configuration for the other side of the relay?
Thanks man, it really helped me.
Does anyone sell a relay board that just plugs into the headers on the dev kit board?
Where do you supply power if you disconnect the usb cable?
@INOVATRIX
4 ай бұрын
There is a pin labelled "VIN" on the board, you can easily connect 5v supply to it.
bro 3.3 and 5v pin of esp32 is used to supply power to esp32 but how we can use it for externa purpose this will harm our board
@INOVATRIX
6 ай бұрын
Board can get power from the "VIN" pin. 3.3 and 5v can run small components.
This is 5v relay, needs 5v power supply and 5v logic level, how does it work with esp32 which is 3v3 ? - is it reliable, could it damage the board ?
@marcsmith2342
3 ай бұрын
I am currently trying to make a relay work with a ESP32, i have a SRD-03VDC (3V) and it doesn’t have enough Amp output i am starting to see
@JoseTrujillo-qz6gv
3 ай бұрын
For me with upython IDE and the esp32c3, this solution has problem when the relay is with load and i think need a transistor for change the 3V3 to 5V.
Balls
@INOVATRIX
15 күн бұрын
Cubes
3.3V to 5V relay ??
@INOVATRIX
11 ай бұрын
Relay is of 5v but works perfectly with 3.3v
@pineappily3119
8 ай бұрын
@@INOVATRIX I am using ESP32 3.3V with Relay 5V. But the switch does not work. If I connect to 5V it keeps the switch on but it does not turn off is there any solution? Thanks!
@DDc220
7 ай бұрын
@@pineappily3119Hello! I have the same problem. Did you find any solution? I use the Esp32 version with 30 pins
@amir_abbas_992sh7
6 ай бұрын
@@pineappily3119same
@summ3rtim373
6 ай бұрын
@@pineappily3119I'm facing the same problem. did you find any solution?
Bro can you please send me coding
@INOVATRIX
11 ай бұрын
I have updated the link in the description.
YUCK