Advanced tip! I recently had to solder wire taps into a 12-conductor pigtail. There's no way you can have a *_huge_* wire splice bubble in the middle of the pigtail where all 12 joins are made. Start on one side of the pigtail, join in a wire, move 1.5" or so and make another join, repeat. In short, if spicing, tapping into, or repairing multiple wires in a harness, stagger the joins.

Yes, I also prefer this method, that is, the use of soldering and varnish. The electric current is transferred better

@newtecpro

8 ай бұрын

Yes, you are right

Yesss yesss yessssss. its good idea.

@PoshtibaniChista

8 ай бұрын

mee to this way is very good.

I advise against putting solder on top by melting the solder next to the soldering iron. It is way better to heat up the conductor from below and put the solder on top. When it melts, it will follow the heat and drip through the strands, effectively reaching out most crevasses.

@newtecpro

8 ай бұрын

Thanks for your very kind comment. This shows that you have carefully watched the video. I will try to use this guide from now on.

@russellstephan6844

8 ай бұрын

Also, get a molten drip to cling to the iron. Then, let the drip transfer the heat and flow into the join.

@newtecpro

8 ай бұрын

@@russellstephan6844

thnx its good way for twist wires

@newtecpro

8 ай бұрын

thnx bro

This way is true methods thnx

@newtecpro

2 ай бұрын

Thanks for liking

Soldering was bad but the twist was good

@newtecpro

8 ай бұрын

Thanks for your helpful comment. Due to the lack of time and to avoid the length of the video, we only showed the soldering process. I hope you will send us your useful comments in the next videos.

Pfusch

@newtecpro

8 ай бұрын

Thank you for your opinion. Do you have a critical opinion about this method?

no. no. no. no. nooooo noooooooooo nooooooooo

@Anderson_Roger

8 ай бұрын

why?

@GuilhermeGomes2

8 ай бұрын

@@Anderson_Roger that is extremely low quality.