How To Test Upstream Oxygen Sensor 1 with a Low Cost Scan Tool
Тәжірибелік нұсқаулар және стиль
How to tell if a bank 1 sensor 1 upstream 02 sensor is bad or good with a scan tool using a Toyota Corolla as an example.
How To Test Oxygen Sensor Heated Element: • How To Test Oxygen Sen...
Amazon Link LAUNCH CR319 Scan Tool: amzn.to/3JyyWEY
How To Test an Oxygen Sensor with a Low-Cost Scan Tool
1. Start the engine.
2. Find the 02 sensor volts in live data or data stream.
3. Pump the brakes.
4. The 02 sensor volts should go up, then down, and back to the original state.
www.backyardmechanic.org
By using this information user assumes all risk of use.
Пікірлер: 22
I have just learnt something NEW. You nailed it in a few minutes pal. I'm subscribing right away!!! 🥳🎊🎉✨⭐✨🎉🎊🥳
Super clear and helpful video! Is there also a test for the downstream sensor?
That was super helpful especially because I have the same scan tool. Thanks!
Ur a real 1
WOW! Thank You So Much!!!
Is you test on an O2 sensor or air/fuel sensor? I thought O2 sensor voltage was between 0.1 and 0.9 volts for upstream O2 sensor.
Is testing the down stream sensor the same method? TY
If the actual sensor reading is good, why am I getting a bad reading on the Air fuel sensor heater circuit response malfunction? What causes the circuit response malfunction?
Unless I missed it, you didn't specify this is a wideband o2 sensor. For narrowband o2 sensors this check won't work.
How do you test the downstream sensor?
Test method 80 fail for bank 1 sensor... What does it mean?
I have a 2004 Toyota Sienna with the 3.3 V6. At idle, both my upstream sensors will hover around 3.2. When I pump the brakes they will each go up to about 3.5 then go down to about 2.8 then back to 3.2. Does that sound correct?
@HVAC_Mechanic
11 ай бұрын
There usually is a bigger jump but it did move so likely good.
@Onedayatatime0915
10 ай бұрын
Same
I have a Toyota Corolla 05 i'v check everywhere I can't find the fuel tank pressure sensor i'v Google it and it's not where it said it would be next step is to drop the tank
@HVAC_Mechanic
11 ай бұрын
It should be on the top of the fuel pump.
@neorome7051
11 ай бұрын
@@HVAC_Mechanic it's not it's not on the tank or the charcoal canister or the fuel rail
@jackjones9460
4 ай бұрын
Look for your part in your local auto parts store parts diagrams before taking things apart.
My b1s1 stayed at 0.00, it jumps to 0.015 and then back to 0.00. Is this sensor bad and need to be replaced?
@unknownplayer7667
9 ай бұрын
Pretty sure
Mine say -127.000 that means it’s bad I’m guessing….
My reading shows 0.000 for bank 1 sensor 1