How To: Solder a Microphone Cable // SAE Institute
Meet Dre Sanchez, Instructor at SAE Institute Miami, as he discusses some tips and trick you can use in your recording.
Dre demonstrates how to solder a microphone cable and highlights the components needed and best practices for a safe and effective solder.
Connect with Dre on Instagram: @dre3001
Learn more about our accelerated Audio Technology, Music Business, and Digital Arts programs, and locate an SAE Institute campus near you: usa.sae.edu
Пікірлер: 20
Thank you, quite clear for a beginner like me.
Thank you very much for your helping us!
Awesome demonstration thumbs up 👍. Thank you.
what kind of solder wire is good for audio?
what solder blend is used?...
It doesn’t get any easier than this guys . If you don’t get this . Then tough luck
hi dude, its the same conection for a condenser mic?
@silviashusband497
6 жыл бұрын
I mean femele and male balaneced...
@TimMer1981
6 жыл бұрын
XLR-3 has a wiring standard for audio, which goes for every audio device that uses XLR-3. This is the diagram for XLR-3: toffer.com/wp-content/uploads/2015/12/XLR3-Wiring-Diagram.png More information: mediarealm.com.au/articles/xlr-wiring-standard-3-pin-5-pin/
Let's see a tutorial on braided-sleeve cables
What if my cable only has 1 wire ?
@alexrangel410
3 жыл бұрын
That's meant for something like a TS cable. You will need to have the 2 conductor cable for TRS or XLR
What's your name on the cable sir
@brynolf11
3 жыл бұрын
His name is Dre on the cable
Apparently they've never heard of a mic pop filter at SAE. Pro tip 1: slide the plastic boot over the cable BEFORE cutting the outside jacket, saves you a lot of hassle with getting the insides of the cable through it. Pro tip 2: got problems getting a rough or very thick cable through? Spread some vaseline on the beginning of the cable. Pro tip 3: NEVER try to wiggle a fresh solder while it's still cooling down like this guy does, it'll weaken the solder, shorten the lifespan of the solder considerably and therefore cause an unnecessary technical liability. A solder should always look even and shiny, never dull.
@atta1798
5 жыл бұрын
Timer1981 you still need to be more accurate n precise. Flux no flux, lead free or not, it appears you agree with the pre soldering steps you need some lessons to do it really professionally.......just getting back to at you the same way you did to the video.....so protip 1 is a logical step pt2 no need for this type of activity, tip 3, that was for presentation purposes n was already solid enough......SAE took its time to reach n show...just be more positive in giving feedback or you can have a video n we can all watch it.
@mixxmanstudios3749
4 жыл бұрын
thats right
Good
helpful, but maybe say ok and alright a bit less 😉
Way too fast for my slow brain.