How to simply drive the motor driver BTS7960-IBT2 | user manual
Ғылым және технология
_ How to simply drive the BTS7960-IBT2 | user manual
_ How to simply drive the motor driver BTS7960-IBT2 | user manual
_ Motor Driver BTS7960-IBT2 Simple operation without code | user guide
_ BTS7960-IBT2 Control Mode : Level
_ Highside's P-channel MOSFET, Lowside's N-channel MOSFET.
_ H-Bridge circuit operating principle | FULL-Bridge
0:04 Hello ~~ Today is ~~
0:14 Let's take a rough look at the working principle of the BTS7960 motor driver.
0:44 This motor driver has a built-in H-bridge circuit consisting of two BTS7960 chips.
0:54 Each BTS7960 chip has a PN HALF-Bridge circuit.
1:09 How to drive the BTS7960 motor driver.
2:00 I will use jumpers to simplify wiring.
2:35 Connect the motor power from the power supply.
4:04 It's not normal operation and it's not even a touch sensor.
4:17 Even with a small current flow in the human body, it becomes a floating state and malfunctions.
4:31 Malfunction can be prevented by using a pull-up resistor or a pull-down resistor.
4:43 This video ends here.
Пікірлер: 9
Thanks
Hello. What will happen when you apply a PWM signal to RWPM and LPWM at the same time? Will it stop or will there be a short circuit and damage?
Can i ask..i have use 24v 14a dc motor and also connect 24v20a power supply to bts7960.the vcc 5v and ground from arduino.but when mptor is running im test to apply load.what happen is that motor is stop running.can u explain and suggest how could it be and how to solve? Tq
@something_else_123
11 ай бұрын
Thank you for watching! Ignoring all other conditions and just guessing from the numbers in the question, the input feels low.
@ParangSkipeers
11 ай бұрын
@@something_else_123 input from supply?
Hi so ..... i can use this driver BTS7..(43A) with my pompe which supports 6A no problem??? Thank you for vedio 😁
@something_else_123
4 ай бұрын
Thank you for watching!
Hi Is your DC motor 12v or 5v please ?
@something_else_123
6 ай бұрын
Thank you for watching! 12v