Nice work. A 1-1/4" socket actually fits better than a 32mm for the axle nut.

Not bad, just did this job myself, using pretty much same stuff, but did both sides, replaced brakes and rotors too. Just a couple notes for anybody doing theirs, check the other side for how the abs line runs so you install those clips right, to get the old hub off go ahead and smack it with a hammer, when replacing the spindle nut just get it started then finish torque when tire on the ground so you don't damage studs, use anti seize on bolts, you can remove two of the three 8mm nuts on the dust Sheild and the tie rod nut if you need more room to work and turn the whole assembly left or right. Great stuff y'all, thanks for making the vid.

@MrSkillsProduction

4 ай бұрын

How would you torque the spindle nut with a tire on? or am i reading this wrong? haha

Nice job guys. Really helpful.

@curbsidemechanics3040

3 жыл бұрын

Thank you

Never hit the cv shaft with a hammer you'll mushroom the threads real quick. Rubber mallet yes.or leave the nut on and hit the nut.

Love you guys better than all the others

Super helpful, thanks bois!

@curbsidemechanics3040

2 жыл бұрын

No problem glad we could help!

Thank you for the close up views. I am studying how to do the complete front end component from the frame to wheels…all rusted parts.

@curbsidemechanics3040

2 жыл бұрын

Where is the truck from?

@curbsidemechanics3040

2 жыл бұрын

And no problem happy we could help!

@douglaswilliams5794

2 жыл бұрын

@@curbsidemechanics3040 truck was picked up in Rhode Island. I needed a small truck out near Connecticut where I grew up. I live in Iowa. I go between to care for my dad part time since mum passed in December. He is coming up on 89 shortly and we needed a light truck to haul stuff. Handy, I chose a ranger because they are easy to work on. Found this one with the V6 4wd with just over 72000 miles for a 2005. Just picked up newer looking wheels and get me by tires for 175$ today…all 4 of them. Working on bumper, 4x4 actuator, and hitch tomorrow and next week. Doing the research for the front end replacement ( suspension, knuckles, bearings, shocks, etc.) for two weekends in late August. As a computer guy, I like having a hobby like this. Thank you for your interest.

nice work guys

@curbsidemechanics3040

2 жыл бұрын

Thank you!

Good details of the job ! Three thumbs up lol

@curbsidemechanics3040

2 жыл бұрын

Thank you!!!

How much was your replacement? Where did you get it from?

Any video for a front wheel locking hub whole wheel assembly replacement? My wheel studs are all completely stripped out of the wheel assembly.

@curbsidemechanics3040

2 жыл бұрын

What year?

What year modle

Nice work, but man that is a lot of grease whipped on your pants lolol

@curbsidemechanics3040

2 жыл бұрын

Yeah it happens

It must suck that FORD out sells both GM and FIAT....

You were doing good until you badmouthed Ford. Then you lost me.