I recognize that tunnel! Have a mk1 Gti in eastbourne

@golfmk2

Жыл бұрын

Ah you know the one! It's very distinctive and rude not to drop it down a cog when you go through! I'll have to keep an eye out for your Mk1 GTI as my parents are local to the area so visit often. 👍

Mate, just a tip from an old long retired mechanic. Always pull a spanner, power bar, ratchet or torque wrench towards you rather than pushing. Enjoying your videos, those V6's are amazing, not quite a straight 6 and not quite a Vee.

@golfmk2

Жыл бұрын

Yes I was standing the wrong side of the engine as it turns out and certainly made life difficult for myself! You'll notice I didn't make that mistake in the videos after this one! The VR6 is a rather special engine by the way of its configuration. Very clever being so compact. From some angles it looks huge, others, very neat and compact. It's a shame they don't produce them any more. Really pleased you're enjoying the videos though. Means a lot.

@MrPropanePete

Жыл бұрын

@@golfmk2 Yes, I did notice that. Enjoying your videos. Cheers.

Guys you should replace the intermediate sprockets when doing the chains as they wear 👍🏻

@golfmk2

Жыл бұрын

This is something that I did look at doing, but actually when we removed the sprocket and inspected it, the teeth are in very good order with very little sign of wear too. Also, when the chain tolerances were checked they were reading +1 and 0, so very good still. With the costs mounting up on the rebuild it's something that I couldn't justify spending more money on, especially as I felt it perhaps wasn't necessary, with the engine being low mileage and the chains were only being replaced due to a head gasket failure, not due to worn chains. A gamble of course, and I may live to regret it!

@garagenorth1864

Жыл бұрын

@@golfmk2 fair enough, I didn’t notice the wear on mine untill I compared it with the new sprockets 😂 I’m sure it will be fine as my chains were right on the limit on vcds

@golfmk2

Жыл бұрын

@@garagenorth1864 I completely understand where you have come from though so was happy to explain my reasoning for not doing so. It's that tricky situation of 'where do I stop' when I comes to something like this. The job was really a repair, rather than an overhaul, but costs have already spiralled as I've been getting stuff done that can be whilst the engine is out and accessible, but I have to draw a line with regards to replacing some parts and by inspecting this I've taken an informed decision not to replace.

you never changed the green o ring in the casing,any reason why

@adrianculley458

4 ай бұрын

5.28 into the video,its on the left side

@golfmk2

4 ай бұрын

Only that the o-ring wasn't supplied in the kit. Otherwise, yes I'd have changed it as a matter of course.

@adrianculley458

4 ай бұрын

@@golfmk2 dont suppose you have the part number for said green o ring by any chance?

@golfmk2

4 ай бұрын

​@@adrianculley458looks like it's this one: N 90041102