How to Replace Boat Trailer Axle and Wheel Hub Assembly | Step-by-Step Guide | DIY
Автокөліктер мен көлік құралдары
In this video, I'll show you how to replace the axle and wheel hub assembly on a boat trailer. This is a relatively simple task that can be done with basic hand tools.
If you're looking to save money on your boat trailer repairs, then this video is for you. Replacing the axle and wheel hub assembly on your boat trailer is a relatively easy task that can be done in a couple hours.
By following the steps in this video, you can save yourself a lot of money on labor costs. And, you'll be able to get your boat back on the water in no time.
So, if your boat trailer's axle and wheel hub assembly are worn out, don't hesitate to give this video a try. You'll be glad you did.
JRMSweeps #jrmsweeps #sundolphin #boats
Here is the video I did on how to replace the leaf springs:
• How to Replace Boat Tr...
#sundolphin #boattrailer #jrmsweeps
keywords:
boat trailer
axle
wheel hub
replacement
DIY
how to
video tutorial
step-by-step guide
automotive
marine
power equipment
DIYer
handyman
mechanic
Пікірлер: 12
Thank you!
@JRMSweeps
18 күн бұрын
Welcome
Nice job on video straight to the point. Just a note: I do hub replacements the same way except I put small amount of grease inside the hub before adding bearings & I hand grease the spindle then install hub. To help reduce the amount of grease ill have to pump in at the end with the gun..... Just a preference. Nicely edited video too.. 👍👍
@JRMSweeps
Жыл бұрын
Thanks for the additional information and the nice comment. I sincerely appreciate that. If/when I need to do a hub replacement, I will follow your advice. Thanks!
I wish I would of paid more attention to this video because I tried assembling the left springs to the axle then put them all in at once,that was a fail,well at that point I found out the company sent me the wrong axle (to long) my stupidity not to check,next time left springs first then the axle after, and other advice is welcome,thanks again buddy 👍👊
@JRMSweeps
Жыл бұрын
Very welcome. I can totally understand what you went through. I spent about a good week researching, measuring, talking to the trailer company, etc., before I finally was able to get the right combo together. You got it going again and thanks for the follow up. Happy fishing my friend!
you need to pack the bearings force grease into each bearing squeezing into the bearing
@JRMSweeps
Ай бұрын
Still running great, ty.
Did he not put in racers?
@JRMSweeps
10 ай бұрын
I only used what the kit called for.
@MrTeff999
10 күн бұрын
It appears this hub had races pre-installed.
@JRMSweeps
10 күн бұрын
Yes