No video
How To Replace A Starter In A Mazdaspeed 3 - FMIC Setup , No Jack Needed
One thing after another 😫 But a quick easy install! No need for a jack. Just a few basic tools and elbow grease 👌🏾
I hope you enjoyed this video.
Like, Comment & Subscribe for more!
Background music - Produced by CrownArtist (Me)
⬆️↗️➡️↘️⬇️
Socializing stuff
📷 iam_crownartist
📧 Guimard23@gmail.com
Пікірлер: 14
To remove the starter, I had to loosen a bolt behind the engine that secured the coolant pipe (the pipe that goes to the top bolt on the starter.) This gave me the necessary clearance to pull the starter out. I also started from the bottom… and then ended up doing it from the top like you said haha… it was much easier
@GuimardJoseph
11 күн бұрын
@@Cruzzz_Controlllthanks for watching! Glad you were able to get it. 🙌🏾
hey joe. great video man. are you able to post a video on how to remove the intake manifold ? i have an 08 Speed
@kdbomination4910
3 ай бұрын
Hey bro, did you find a good video for removing the intake manifold? I’m looking for one
@GuimardJoseph
11 күн бұрын
Sorry for the late response. Unfortunately I don't have a full video dedicated to that, but you can use this video as a reference. I hope it helps. kzread.info/dash/bejne/p2ybu62xh8zMc7Q.htmlsi=LkzYydf6q_Kk7djf
Just found you bro. Good info 💪🏾. Working on my Speed as we speak.
@GuimardJoseph
Жыл бұрын
I appreciate the comment! Glad you enjoyed the video. Good luck with your project 🙏🏾
My car died out then tried to start it but no good. Charged it then started it and it started scratching kinda had a idea it was the starter ..
What year is the speed3 cause for the 2013 i think they have 2 starters only a day apart
@GuimardJoseph
Жыл бұрын
2011
You don't need to take the manifold off.
@GuimardJoseph
2 жыл бұрын
Yea, but I like to see what I'm doing and removing the manifold isn't hard at all. The more room I have to work, the better. Thanks for the comment!
@Solarlifeoffgrid
Жыл бұрын
Yes you do have to take the manifold off if the bolt is not comming off bt yeh if the bolt is rusty and yeh i would done the same thing as he did... Great vid as well ima have to take it off to cause that bolt is not comming so i gotta have room
@FCRx7
2 ай бұрын
You can get the starter replaced by just taking the throttle body off, and intake / FMIC pipes if they’re in the way. Just did mine last night. Intake manifold can stay on