How to replace a belt tensioner and drive belt, Toyota Highlander/kluger ,3.5 V6
Автокөліктер мен көлік құралдары
In this video I will show you the easier and faster way to change your 2008 to 2012 toyota highlander / kluger serpentine belt and belt tensioner replacement.
If you are looking for help with your Automotive Repairs, Automobile Installations, Mechanical Repair or Adjustment, please head over to carfix for information on it
Please drop your comments and subscribe if you like my videos. Thanks for all the support.
Belt Tensioner: amzn.to/3e2xUV7
Drive belt:amzn.to/3rzfH4k
1/2 deep socket set:amzn.to/3fLBa7K
3/8 Socket set:amzn.to/3RzgdKh
Coolant:amzn.to/3CwdZqT
*Disclaimer
We are not responsible for property damage or injury incurred as a result of any of the information contained in this video. Information given in this video does not guarantee the desired outcome. Any injury, damage or loss that may result from improper use of the tools, equipment, or the information contained in this video is the sole responsibility of the user and not carfix
Пікірлер: 25
Exactly how it should be straight to the point, great job my brother
Nice video not too much talking straight to the point
Nice! Finally this confirms that you don't have to discharge the AC system to remove the compressor to replace tensioner You could just move it away to make room to remove the tensioner bolts.
This video reminds me my apprentice days! I definitely miss my mentor
Thanks for the video!
Hello thanks for the video , did i missed the torque spects for those bolts on the tensioner ?
Thank you kindly😁
You are a hero my brother , You are one of a kind Thanks alot for putting out such an amazing vedio.
@carfix1993
Жыл бұрын
Thanks mate
@jeromepatterson474
Жыл бұрын
I like and subscribe to your channel Thanks again
@carfix1993
Жыл бұрын
Appreciate mate
Well done. Nice camera angles. Would you recommend changing it with car over 200,000. I will be replacing the alternator, and was thinking of doing tensioner too. Thank you for sharing.
@carfix1993
3 ай бұрын
It's ok otherwise double job If you can change it same time
Do you need to take apart everything shown in your video of you are just replacing the tensioner?
@carfix1993
Жыл бұрын
Yes just replacing tensioner
Hi mate i have the same problem so if I don't changed what will happen? Thanks
@carfix1993
Жыл бұрын
It will stuck belt tensioner and drive belt will brake then water pump not turning your engine will be overheated
@Assyrian11
Жыл бұрын
Thanks mate 👍
Love my camry 3.5L BUT THIS IS RIDICULOUS TO BUILD A CAR WHERE THE BELT IS A BREEZE TO CHANGE BUT THE STUPID BELT TENSIONER IS A NIGHTMARE. smh
Good video! How long did this take?
@carfix1993
Жыл бұрын
Nearly 3 to 4 hour job
All you have to is replace the bearing on the tensioner. Not the whole tensioner
@imaipodfan331
Жыл бұрын
The whole tensioner had to be replaced on this one. The tensioner's arm was creating the squeaking noise due to there being an excessive gap. The tensioner's bearing had nothing to do with the noise.
@andrewsnider4098
Ай бұрын
I just replaced the tensioner pulley on my 2007 Sienna and the noise remains. I should have tried the trick at the beginning of the video so that I would know that it was the tensioner itself.