Word of advice.....If you're ONLY changing the break pads either in the front or back on a 2014 Toyota Camry and NOT the rotors, there is no need to remove the entire caliper like I see many people do. Just remove the upper bolt and let the caliper swing down making sure to tie a rope or bungie cord to avoid it hanging too low and damaging break fluid lines. Much easier and faster than removing the whole dam caliper for NO reason. 😎

@ARASHKAGE

2 жыл бұрын

Thanks for sharing that tip

@jaredpatterson1701

2 жыл бұрын

Yep just learned this yesterday after changing my pads on my chevy impala 2010, but sometimes the bolt is on pretty tight. I also saw that the pads don't wear down evenly and I did not need brake fluid like my mechanic claimed. It seems the pistons that pump the pads had to compensate for worn out pads, making the fluid appear low because afterward the reservoir was full. Had to use a C clamp to push that things back in. First time, but I saved 450$

@trevorvanausdoll3709

Жыл бұрын

Why would you want to completely miss the opportunity to destroy a brake line?

Straight forward and easy to follow....thank you!

nice job! i like how u show applying grease.....good for visual

You make it look easy brother, Im going to do this tomorrow on a 2014 Toyota Camry LE, thank you!

@mharkiemark84

3 жыл бұрын

thanks

@uzzulht

3 жыл бұрын

How was your experience

@DFWAuto_Hack

2 жыл бұрын

@@mharkiemark84 no socket or bolts size my friend?

@mharkiemark84

2 жыл бұрын

@@DFWAuto_Hack socket size 14, bolt size 10.

I would use silicon grease for the glider pins. Put a little grease on the piston and the back of the pads where the caliber makes contacts. I would properly remove the brackets and clean off any rust under the hardware where the pads slide. I'll be doing my 2016 in a few months.

A very clean job. Well Done.

1st thing is open the brake fluid reservoir to catch any leakage in case it was topped off while the brake pads were worn. The leakage occurs when the brake caliper piston is compressed.

@tanklergaming103

Жыл бұрын

also this would avoid any potential ABS issues

Grateful for the video it will save me waiting room time and $$$

Thanks for the video it has been very helpful.

Love the dance and song routine. Nice mid class entertainment

Could've turned the wheel for easier access. but otherwise great job

Is there any sensors i should be aware of? Changing mine this weekend

Are the two wire clips not necessary for the new one u put in.

@mharkiemark84

3 жыл бұрын

Its an anti-vibration/squeal spring/device.

@bigstick8699

2 жыл бұрын

Are you referring to the retaining pins?