Awesome technician 👌

@dentdetailpdr

5 ай бұрын

Thank you kind words, thank you for watching

Nice Graham 👌

@dentdetailpdr

5 ай бұрын

Thank you for watching

Wow. Impressive!

@dentdetailpdr

5 ай бұрын

Thanks for watching Eugene, much appreciated!

Very good

@dentdetailpdr

5 ай бұрын

Thank you for watching

👌👍

@dentdetailpdr

5 ай бұрын

Thank you Tim

Nice job, I have the similar dent over there. Is there a reinforcement structure beam near the dent?

@dentdetailpdr

4 ай бұрын

Hi thanks for watching. It will depend where your dent is exactly, an inner beam runs all the way across the bodyline in side there, so yes, if your dent is where the one on the video is, there is a beam you have to navigate round

Excellent work buddy. When you're using a hard tipped tool to remove the dent does is not mark the inside of the door? I know manufacturers normally coat the inside of the door with cavity wax as it gets wet from rain water and washing. Just thinking about the possibility of future corrosion from the inside-out?

@dentdetailpdr

5 ай бұрын

Thanks for watching Craig. Some very sharp tipped tools can mark the inside of the panel, but not in this case. E coat or etch primer can be applied if this does happen, but it’s very unlikely that it does if repaired properly. You’ll be surprised how many new cars don’t have cavity wax on the whole of the inside of the panels, it’s only common in older cars

@craigf5536

5 ай бұрын

That's good to know. How much does a little dent like that normally cost to remove?@@dentdetailpdr

@dentdetailpdr

5 ай бұрын

@@craigf5536 no problem. Depending on the location on the bodyline and the severity of the dent it can range from £145-£245+vat, sometimes we have to remove the door card as not all are accessible through the locking latch

Do you teach pdr at your shop or possibly come to us

@dentdetailpdr

5 ай бұрын

Hi Colin where are you based?

I'm wondering how much was this work?

@dentdetailpdr

5 ай бұрын

Hi thanks for watching and for the question, dents like this are around £195-£245+vat GBP depending on the severity of the dent

Temperature ?

@dentdetailpdr

4 ай бұрын

Hi, we get the panel temperature on aluminium panels at 29 degrees to work it, this is the same for glue pulling and pushing. Compared to steel panels at around 21 degrees