How to make Planer Boards
Тәжірибелік нұсқаулар және стиль
Check out how to make planer boards DIY and cheap for striper or other large fish and even crappie too.
Everything you need for the build.
amzn.to/34AIGXz Lexan these are 12x12 and must be cut to size 8x10
amzn.to/36QmDxJ I-bolt 1/2x6in
amzn.to/2QgKZKz 1/2 hex nuts
amzn.to/2PFI1QI washers
amzn.to/2ECMaOM Clevis
amzn.to/2EC4lV2 Line Clip I think theses will work better
amzn.to/2sGX6Ix Split rings
amzn.to/34IYqrv Styrofoam cut to 10x2x2 we wrapped ours in duck tape for visibility.
These may not be the cheapest prices on the supplies out there but they will get u everything u need for this build. I couldn't find exact quantities but you should be able to make multiple boards with this most of this stuff. Thanks for watching make sure to subscribe and like this video.
#UntamedFishingAdventures #PlanerBoards
Пікірлер: 21
Let us know how yours turned out!
Great video! Can u use this while drifting? Or do u need to be trolling? Thank u
Nice job
Like it. Gonna try it.
@untamedfishingadventures8515
4 жыл бұрын
Ebber Jr3 let us know how it turns out.
I’ll be making a follow up as soon as the weather breaks to show you guys how these run! You will be super impressed how well they spread out! Be on the lookout in the next week or so!
@campnoutdoors1621
2 жыл бұрын
I was going to subscribe but you never did a follow up like you said you were going to do. My guess is you lost interest in doing the channel. I just made some planer boards but used cedar and epoxied it to the lazan. Made em 6" X 12" so will have to see how well they work
Where is the video about how to use these planer boards ？I looked your channel for all your videos and could not find it
How long did these hold up and do you have any videos fishing with them?
We have a video about to hit the channel to show y’all how these planer boards go to work being pulled down the water!!! Check it out tomorrow or Thursday!
Do you think I could half that build for smaller crappie boards ?
Could you use 1/4"x4" for the bolt?
@untamedfishingadventures8515
4 жыл бұрын
Cher Vue I say you could give it a try! That would keep you from having to run it about a inch lower like I did in the build. It may be worth the try. This build I know works for sure!
I made these exact ones following this video and they just sink, only the foam stays up.
How thick is the plexi glass
@johnmoore5293
11 ай бұрын
The thickness is about 3/32" . Plexiglass can break, Lexan won't break.
Cool but spend the $30 once on a on sale board and use that board for the next 30 years.
@austinlee6444
5 ай бұрын
What brand is reasonably priced and somewhat good quality
I made these. They didnt work
@logieberra
Жыл бұрын
Old mate didn’t follow through with the demo video he promised. Poor form!
@leo8505
Жыл бұрын
Same with me, should of just bought them premade