Can we do it in sheet metal duct?...same process

What is the 1.4 for I always do the owl method offset witch is 3 times the width divid by length witch gives you the distance between the cut

@AZSolutions92

8 ай бұрын

1.4 X Offset gives you the distance between your first and second cut when you use a 22.5* template. Around 3:40 in the video you should see the two marks where the template will lay on for a reference point. I got the 1.4 from a few good mentors they said don,t question it just use it. 😂

I have a have 25 inches metal duck length...and its 12×12 ... I need a offset of 10 inches ....can i use the same process..like you did in this video...i don't have the template...can i use my square ....nornal square....and put 22.5 on it ?

@AZSolutions92

5 ай бұрын

Yes its the same process , and a square will work too 👍 good luck bud

The easiest way to make an offset is just times it by 2 so if you're going to 3 inch offset but you need to do in between the marks is measure it'll be six just times the three by two if it's a 7-inch offset it'll be a 14 you see how I did that 7 inch offset times it by two 12-in offset times it by that is the easiest way to do it and plus you need to know the length so how far off is your offset so if you got a piece of duck in the air and you got to go a little bit further I mean your ducks going to be attached so you know it need to know where the offsets going to be can you measure to the offset spot and then you just times it by 2 it's pretty simple

I like this video I hope your next video teach how to do 45

@josephnelson5006

2 ай бұрын

45 just use the 22.5 angle back to back fold duct in and tape

Keep up the work. what size duct is that one in a half?

@AZSolutions92

10 ай бұрын

Thank you, and yes its 1-1/2” duct. 👍

Can you make a vedio how to make a box top and how to 4 peice please.

200/200 Ofset 150sending vidio

@AZSolutions92

7 ай бұрын

Thanks 👍