how to make a strong pipe wrench

Тәжірибелік нұсқаулар және стиль

in this video, I want to show you the prosses of how to make a strong pipe wrench
...........................................................................................................
time codes
0:00
............................................................................................................
if you want me to share more about an experience make sure your comment below and don't forget to subscribe and like
bit.ly/3ud08QY
............
Hi. I am Mohammad Kazemirad an industrial designer and producer with more than a decade of professional work experience in the design and execution of complex engineering projects including elevators, lifts, industrial machinery, and mechanical systems including a US patented tunnel relief device.
in this channel, I want to share my knowledge with you and I try to test and challenge every simple and complex project. I do A-Z of a project that consists of designing with software (SolidWorks, AutoCAD, 3DMax, V-Ray,...), production(welding, sheet metal working, turning, milling, ....)
I hope You and I learn a lot and we catch lots of experience.
.......................
#pipewrench #relietron #simpletools

Пікірлер: 4

  • @koala_craft
    @koala_craft Жыл бұрын

    That was awesome

  • @weldercreative2.m970
    @weldercreative2.m970 Жыл бұрын

    Good luck

  • @cokhichetao72
    @cokhichetao72 Жыл бұрын

    👏👏👍👍

  • @analogman1909
    @analogman1909 Жыл бұрын

    Skip the build vid, step right up and see a 'pipe wrench' demonstrated on a nut and bolt...... Play by play "Make a Strong Pipe Wrench" ? 0'.05" in, a Grade III bolt. At 0'.25" fully half the engagement diameter is ground away; not flat, or parallel in either plane. At 0'.40" notch for the adjustment nut; not parallel seat for nut, nor allowance for thrust washer. By 0'.42" prepping to weld the handle. Instead of this being one piece, that and lower jaw are welded not only at narrowest cross section, but where the strain of torquing is highest. Now, 1'.36" two cheek pieces welded on, on top of handle weld, instead of overlapping. Of course, here in 2'.40" threaded portion attached to upper jaw, again at narrow juncture. My favorite, 2'.55" and countering industry standard of sharp milled teeth; angle grinder and narrow cut off wheel. Maybe intended only for threaded copper, garish internet paint step eliminates potential hardening of said teeth. Closing seconds of vid, it's demonstrated on a nut and bolt, IIRC are straight threads, not taper of pipe with increasing force needed to drive a tight joint. Right in step with trendy adoptive identities, a filmy shadow of a pipe wrench, but terrific paperweight.

Келесі