Thanks Rob! Hello from the Land of Thousand Islands! The Philippines! I'm using a Yoshan 1kg. A new subscriber.

@ocdcoffeeclub4796

23 күн бұрын

@@01redlightning welcome! Thanks for subscribing 🙏🏻

Thanks Rob! Helpful as always

@ocdcoffeeclub4796

Ай бұрын

You got bit.

Thanks for another informative video Sir.

@ocdcoffeeclub4796

Ай бұрын

You got it!

Hi Rob, just the video l needed.

@ocdcoffeeclub4796

Ай бұрын

Awesome!!

Awesome content Rob, appreciate you helping all of us! Is there ever a need to lubricate anything else on the machine? Have you ever had to do any maintenance on the drum motor chain?

Thanks once again rob. I was going to contact Erin about this but this has probably saved me a lot of time and money. have you greased the back bearing? I need to take the casing off and check again because I think I saw another video of someone greasing a nipple. Have you checked this before? If not I’ll have a look

@ocdcoffeeclub4796

Ай бұрын

You know, I haven't yet, but I need to. When I do, I'll make a video of it.

So, your replacement bearing # is ending in a single z not zz ? Meaning only one side is sealed or closed vs both.

@ocdcoffeeclub4796

Ай бұрын

It’s supposed to be ZZ. I’m glad you plotted that. I’m going to update the link.

Rob what you think about the wintop roaster? Thanks

@ocdcoffeeclub4796

14 күн бұрын

You know, I've never seen one in person. They look nice, but I can't really give you an opinion. Sorry.

I can’t get the square metal piece off for the life of me

@ocdcoffeeclub4796

Ай бұрын

You’ll most likely need a new bearing if yours is stuck on. Is it squeaking? Make sure you order the bearing and lube and have it ready for removal or you’ll have to wait after removal to fix it. Use a screw driver and try to get between the housing and the front face of the roaster. If you have lubricant, rub a little on there and see if you can get it free. You can also use plumbers pliers to try and get a grip on the housing to pull it away. Might want to use a small microfiber towel and place it between the tool and your roaster parts in order to not scratch up your roaster.

@ocdcoffeeclub4796

Ай бұрын

How long have you been using the roaster? Have you ever lubricated it previously?

@kalebgriffin1993

Ай бұрын

@@ocdcoffeeclub4796 no squeaking or anything. Actually, probably after a week of having the roaster and finally getting it set up, I was able to do everything needed to the back bearing and adjusting the drum gap and such. I did attempt to get the front plate off at that time too, before it had even ever been roasted on. It’s a 2kg machine that I’ve had for probably 2 years now and have roasted less than 200-300 pounds