Very helpful, thank you! These videos are also well done, btw. Thanks again!

@HardscapeCanada

Жыл бұрын

Thank you!

very nice video. Some nice videos you are producing on your channel. Does the ground beneath the base also have to be graded in a similar way to the base? I have done the hard digging but feel I need to spend a little more time filling the lows and shaving off the highs before I put the base down.

Thanks for a good video 👍

@HardscapeCanada

Жыл бұрын

You are very welcome!

Great video. What roadbase are you using? Crusher, rock screener or something else?

Kev, I’m plan to lay pavers that slope down from a covered concrete patio. At the end of the slope I plan on placing a channel drain. The paver area is 18’ x 25’. 18’ is the sloped dimension. Im using Belgard’s Catalina Grana 3-piece small. My question is, can I get away with a 1” slope or would you recommend a 2” slope. I have 3/4 road base down, compacted and will have 1” of bedding sand.

@HardscapeCanada

Жыл бұрын

Hey sounds like you’re on the right track! 1.5% slope for 18’ length is (18x12”) = 216” x1% (minimum slope) =2.16” 1.5% (ideal slope in my opinion) = 3.24” So bare minimum is 2”, I would go to 3” to make sure water flows off the surface nicely. It will still feel flat if the entire surface slopes in that one direction.

Put a level form board on the sides of the area to be screeded and screed off of them for a flat surface. The ground underneath the base rock should be slopped for drainage if necessary.

So are you getting your final slope in the last roadbase lift? are you just using the level lines as reference? Are the marks on the 2x4 supposed to line up with the level lines?

@HardscapeCanada

Жыл бұрын

Technically you are setting the final slope at the beginning with the string lines. Then simply working up to them, with all of your roadbase layers and final screed. Yes you can make marks, or notch out the ends of a 2x4 (size depends on paver) taking into account about 1/2” for compaction of the final roadbase layer, to get ready for bars and sand.

Do you recommend stone dust anywhere during the install? Thank you for the videos!

@HardscapeCanada

Жыл бұрын

Hey I hear a lot about stone dust, however I have never used it due to it not being available in my local area!

when he hammered the stakes in i thought my computer was breaking

@DuckDaPhillyFan

9 ай бұрын

😂😂😂😂😂😂

@DuckDaPhillyFan

9 ай бұрын

The dog here barked

Just wanna make sure here! So the string lines are the highpoint of the futur patio. You than retract an halfinch from your 2x4 to make it 3 inch width to simulate the last 1inch layer of roadbase and the 2 inch of pave ? Thanks for your time ! 😅

@HardscapeCanada

Жыл бұрын

Basically yes, the roughly 1/2” off of the 2x4 will get you to the final height of roadbase, then you will be adding exactly 1” of sand and your paver (widths vary but typically 2” 3/8

Can't find part 3 either. Would have been nice if you included links to the various other parts.

@HardscapeCanada

10 ай бұрын

kzread.info/dash/bejne/iWVo0tKRaMu9qMY.html

I already have landscape rock laid down and don't want to have to dig it out to try to level the ground under. Would it be reasonable to lay gravel over the rock, either on a rock blanket barrier or no barrier and just lay it directly on the rock? I'm putting flagstone on top to make a pathway that I want as level as possible for my elderly mom. Help 😊😊

@be_reselient

9 ай бұрын

Ive done mostly all of my Patio in my backyard, without level base. It starts to get uneven over time but as long as you dont concrete it down you can alway make fixes…

SUPER informative instructions. Quick question, where do you get your stakes? I can't seem to find anything longer than 8" from the big box stores, and I think I'm Googling the wrong terminology.

@user-vo9gd4ue5t

8 күн бұрын

Masonry stake for concrete forming Look at Home Depot next to the string in masonry aisle

Getting ready to pour a backyard patio, when sloping away from the house are you sloping the base or the slab itself?

@HardscapeCanada

2 ай бұрын

Both!

@pawneep20

2 ай бұрын

@@HardscapeCanada gotcha now what’s the easiest way to slope it for a diy project

@HardscapeCanada

2 ай бұрын

Here you go! THE ONLY WAY TO SETUP SLOPES!!!!! Everything you need to setup slopes for any project in your yard! kzread.info/dash/bejne/la19j8mihL3anKw.html

@GT-elqt

2 ай бұрын

​@@HardscapeCanada awesome clip and excellent explanation. Thank you!

So if youre adding the road base, do you measure heigh to the lines before compacting? Also I assume you're measure for 3" off along the line to make sure you're slope is going correctly? Then add final soil and measure say 2" along the lines so when you finally lay the pavers down they should sit flush with the lines? Not sure why it sounds so complicated to me lol

What really confuses me is the consistent slop.... so when I set my lines where I want the patio to be at, for example, a stand-alone fire pit with paver platform, I would do my calculations to get the slope, so drop a inch is that's what it calls for.. then I would still dig say 7 inches all the around and set the slop with the base and follow it with the sand? Or do I dig 6 inches on 1 side and 7 on the other to get that 1 inch slop or whatever it calls for? Hope to hear back from you, and thanks for the video

@HardscapeCanada

Жыл бұрын

Hey, yes you want to set your string lines to the final height and slope, and then you would dig down below the stringlines everywhere to your 7”. Once the strings are set we don’t have to think about the slope anymore, we can just work our layers up to the strings and be sure that the finished surface will have the slope we want. Make sense?

@kristianjovanov2666

Жыл бұрын

Thank you yes makes sense now I think I was just over thinking it

What size do you recommend for your Roadbase/AB? 1/4" minus, 1/2" minus, ......

@HardscapeCanada

Жыл бұрын

Typically 3/4” minus for the roadbase layer

what crush dif you use Kev? Thank yo

@HardscapeCanada

Жыл бұрын

Hey I used a gravel commonly called ‘road-base’ or road crush.

Is your road base permeable? Or does it have to be clean 3/4?

@HardscapeCanada

Жыл бұрын

This road base is not permeable, but you could switch it to a 3/4” clean crushed gravel and use a permeable paver on top to complete the system.

@yemaste

Жыл бұрын

@@HardscapeCanada When would you use this instead of a traditional paver with a perimeter drain?

I need to put pavers at the entryway of my screened enclosure. My problem is that my concrete slab/porch has parts that extend out and above my ground level. The concrete is ragged (overspill) so my pavers won't sit flush against the concrete if i place them ground level. I will need to install them above that rough extension of the concrete. I guess I need to raise the soil level, but then the rest of my lawn will sit lower. What do you recommend i do in this case? Please keep in mind, I'm an older lady who can do anything too labor intensive, like cut the concrete or something crazy like that.

@030francoable

6 ай бұрын

Use a chisel and hammer to knock of the concrete in the way

What boots are you wearing, I need a good pair for landscape construction

@HardscapeCanada

Жыл бұрын

Best ones I’ve found so far are Keen Utility ‘Reno’. Lite but strong and waterproof. Last much longer and keep your joints feeling great compared to leather.

@bullseye0112

Жыл бұрын

@@HardscapeCanada can you dig with them without ripping the bottom up?

Someone please answer this. So you have a level line on perimeter. What about the middle or interior area? How to you find level based off the perimeter level strings?

@HardscapeCanada

Ай бұрын

Once you set your perimeter lines to the appropriate slope, ideally in one direction, you can setup secondary lines anywhere for the middle using the heights of the perimeter lines as your reference

@johnwilkins3995

Ай бұрын

@@HardscapeCanada thank you very much. So maybe one through the middle of the rectangle? And the 2”x4” should reach enough to level the whole area? Is there a good video or source that displays this?

@HardscapeCanada

Ай бұрын

@johnwilkins3995 hey yes checkout the same video above one more time! Skip to 1:25

@johnwilkins3995

Ай бұрын

@@HardscapeCanadasuch a help, really thanks. Gonna give this a try myself bc too expensive and I need a patio.

Where can I find part one? I looked and can't find it. Thanks.

@HardscapeCanada

10 ай бұрын

kzread.info/dash/bejne/nWGWqayumdyaks4.html

Confusing

Background music disturbs and annoys.