Hello, could you tell me the color of the wires for the rear speakers, I only know green and green with black, what color is the other speaker?

@khmerohio

Жыл бұрын

Right rear is white-blue/black

@falcon_gaming95

Жыл бұрын

​@Khmer Ohio I'm installing a sub and amp on a 2015 impala, old body style. I was going to hook my remote wire to the factory amp on the red and white battery positive. But my amp stays on and hums when I did it that way. Any other spot in the rear for the remote wire?

Great sharing skills you got!

Thank you !!! Your the man G

2015 impala ltz. W Bose audio . Tapped Into left an right rear . Used the power off the LOC2 for the remote . Takes a good minute to shut off any after power is off, debating just running remote off one of aux plug

@khmerohio

Жыл бұрын

Run a remote to aux plug

2014 Impala with Bose. I want to tap a remote wire from the Bose amp to the aftermarket amp. What color wire should I look for on the Bose amp???

Will this install be the same for 2019 impala without a Bose? And did you run anything from the radio?

What fuse did you tap into for remote

Ok I got the same car and hooked everything up the same way you did but for some reason everytime I start my car I get the subs that go with the charging system turning on like the radio is on and it’s not but they will throw bass out of them from low to high. Please tell me a song for this cause it’s driving me crazy! The only thing I didn’t cut was the purple and pink wire cause my son said that runs my microphones in the front so please I need your advice!

Best video I've seen on an Impala install. Keep up the good work

@khmerohio

2 жыл бұрын

Thank you sir

@ibethpenaloza2705

2 жыл бұрын

@@khmerohio i huck up my system on my impala but i have the buzzing bass noise when i close the door and when i open the door it goes away u think by cutting the purple wire it will fix it?

@khmerohio

2 жыл бұрын

@@ibethpenaloza2705 yes but make sure you have a good ground

Thanks for the vid! I have the same exact vehicle and installed it per your instructions and everything works perfectly!!! My only question is because of the included remote wire, does that mean my amp will constantly be powered? Don't want to kill my battery if that's the case. Also, my subs randomly "boom" even though the vehicle is off. Any suggestions??

@khmerohio

2 жыл бұрын

Did you cut off the ANC ?

Good sharing!

Got a question, I have the same car year and model but not sure if that one is a LTZ well the question is I don’t see the anc connection in the amp I see the plug and some wires but it looks very different from the ones in the video I can shoot some picks so u can see for your self

@khmerohio

2 жыл бұрын

$one4 seven-78/68nineeight

@dagratesevr1543

2 жыл бұрын

I think it’s missing a digit not sure what the money symbol is

Sorry if this has been asked before...but what did you connect the remote wire for your new amp to? I have a 2015 LT and I tapped into the rear cigg but I'm having a power leak. Also, the stock subs are the in the front doors not the rear. Thank bro

@khmerohio

Жыл бұрын

You can go on to the main wire out of the ignition switch there you will find a pink wire which is ignition wire

@khmerohio

Жыл бұрын

I would just get a kicker LOC it's called kisloc2 that will give you a remote wire output to the Amplifier

@sayitainttone88

Жыл бұрын

@@khmerohio thanks buddy!!

how would you hook it up if you were doing a highs amp as well as bass amp?

@khmerohio

Жыл бұрын

Check this out! a.co/d/jhaMN2M

I have a 2017 Cadillac XTS with Bose System. And I get that HUM from subs after the car is powered off. What do I need to do prevent that??

@khmerohio

Жыл бұрын

Where / how did you run the remote wire?

Can you help me find the AMC wire on my 15 Impala LTZ the black plug in the Factory app only has one wire coming out of it

@khmerohio

Жыл бұрын

Maybe you don't have the ANC..

Why did you pull signal from only left side? Why not both sides? Could also pull power and ground for LOC from amp constant power. Signal wires should tell LOC when to send signal for activate. Will a 2017 have the ANC?

@khmerohio

2 жыл бұрын

Check to see if you have amplifier right side of trunk. It's easy to run one side because I don't think anyone is going to fade their radio to only one side

@jamaltalley5868

Жыл бұрын

What can I do if my factory amp not working can I buy a kit to run my other amps

Worked great thanks man you legit!!!

@khmerohio

2 жыл бұрын

❤️

Hey I have a 2018 impala is the anc wire the same color in my car?

@khmerohio

3 жыл бұрын

Yes

@azara38

3 жыл бұрын

@@khmerohio thank you so much!!

Hey man, so my schematics are down and I've got a 19 impala LT at my place right now. Was wondering in a non-bose unit, what color plug ANC wires were in and what pin number if you could help me out. That would be awesome. I'm having some issues with my install. Thank you in advance. Love the content!

@khmerohio

2 жыл бұрын

Give me about 20 minutes

@xhead4chex327

2 жыл бұрын

@@khmerohio ok awesome. Thanks man.

@khmerohio

2 жыл бұрын

Lf blue-brown/blue lr=green-green/black Rf=yellow-yel/black rr=white-blue/black

What is the color for both rear door speaker wires. I have 2017 Impala. No Bose.

@khmerohio

2 жыл бұрын

Lr is green+. Green/bk - and RR is white+ blue/bk-

@dannyceballos5621

2 жыл бұрын

@@khmerohio thanks. Best video I’ve seen for my car. Going to add two 6x9 to rear deck with small two channel amp. The rear speaker wires I’m going to tap onto should be ok for the signal?

Where did you run the remote wire in the engine because it’s not connected to the battery

@khmerohio

10 ай бұрын

Honestly, i forgot, but look for accessory or ignition fuse

Installed hi-lo converter in 2017 impala. Followed your vid with speakers wire with factory wire connection In trunk. But when I turn vehicle off the amp still has running power to amplifier and does a bass humming

@khmerohio

2 жыл бұрын

What is the brand of you LOC? Hilow converter

@kountryboiktkountryboikt4140

2 жыл бұрын

@@khmerohio scoshe loc90.

@khmerohio

2 жыл бұрын

Best way to do is to run the remote wire from the accessory fuse

@kountryboiktkountryboikt4140

2 жыл бұрын

@@khmerohio ok I'll run it to the fuse box under hood. That should solve the issue correct. I didn't clip the noise cancelation wire like you.

@thtnig

2 жыл бұрын

did you ever get an answer? I have the same problem on my 2014 ltz that I installed today. I think I'm just going to run the remote wire that came with my kit and not use the remote wire from the loc

Hello! Did you end up removing the remote wire or tap into the power. I have a 16 ltz impala and I’m about to put my sub in. Thanks in advance

@khmerohio

3 жыл бұрын

Yep I used the hi/low converter to power the amp don't need that accessory wire from fuse

@larryhood439

3 жыл бұрын

@@khmerohio You the man!! If you knew how many KZread videos I’ve watched trying to figure this out you would cry 😂😂. Really appreciate it! New sub

@kadancekretzschmar9792

2 жыл бұрын

@@larryhood439 hey i have a 15 impala and i have the radio that slides up so i’m just confused on how or what or where to connect rca adapter and such

@larryhood439

2 жыл бұрын

@@kadancekretzschmar9792 I have an the LTZ series and in the trunk there’s an amp. If you have the lt or so series I think yo can tap into the wires from behind the glove box. ( I’m not an expert btw 😂😂)

@larryhood439

2 жыл бұрын

@@kadancekretzschmar9792 if you got an email I’ll send a video on what I did

I know everyone is asking this but is there an anc in an Lt model, I'm not seeing it on diagrams or in person, but the louder the mucic goes the less bass i have

@khmerohio

Жыл бұрын

That is not anc

@khmerohio

Жыл бұрын

Do you have a factory subwoofer

@LegendCampbell

Жыл бұрын

I just installed an audio converter and a 10" skar with a 500rms amp

@khmerohio

Жыл бұрын

What is the brand for the converter i think your converter is bad

@LegendCampbell

Жыл бұрын

If u don't think the anc is countering the bass frequency then I'm gonna guess my the amp is bad, the converter is new but i don't recall the brand name. When i was adjusting the gain it cut out but not like protect mode, i was turning it down then i tapped it with the screw driver and it came back and didn't happen again. That's my though process anyways lol the amp is like 15yrs old now

those 4 wires you got running to the amp on the left side. where do I get those from

@gooninggoo18

2 жыл бұрын

@@khmerohio i got a kit from best buy for like $109 has everything truconnect 4AWG 1400w max power rating. I'm running two 10 inch kicker comp R with a 1600w pioneer tru connex TC-Loc2 . 2019 impala premier

@gooninggoo18

2 жыл бұрын

Will these wires be safe if I dont bump full volume

@khmerohio

2 жыл бұрын

4g is perfect !!

@gooninggoo18

2 жыл бұрын

@@khmerohio got it installed this afternoon, 50 percent volume is more than enough bass. Anything north of 70% is overkill.

Why do you cut the anc wire and where did you run the remote wire from?

@uptemposhoes6139

2 жыл бұрын

did you ever find out??? because i’m not seeing the same color wire on mine…

Where is the anc cable on on a 2014 Ltz?

@khmerohio

Жыл бұрын

Should be the same place friend

What are the front speaker wires?

@khmerohio

Жыл бұрын

Left front: blue-brown/blue and Right front: yellow-yellow/black

@luismc2219

Жыл бұрын

Thanks man ima try to connect the front speakers to the rear and see if i get voice out of the front speakers

Did u put new sub speakers in or what

@khmerohio

2 жыл бұрын

Yes

En español el video porfas

Do you have a business in Ohio that U install systems I live near Dayton Ohio and I’d like you to install my system

@khmerohio

2 жыл бұрын

Yes

@khmerohio

2 жыл бұрын

Extreme Audio Outlet 2741 Sullivant Avenue Columbus Ohio 43204

So I hooked it all up did not have a purple and blue wire on my black plug and im getting like no bass from my system any ideas?

@khmerohio

2 жыл бұрын

What is the name of the LOC? Let's find out why no bass first .. check the back of your subwoofer see any loose connection .. are you for sure your amplifier works? It could have a blown channel

@somkiatthotsaraj3734

Жыл бұрын

I have this same problem. All brand nee components. I even got a signal booster. It just won't bump either. Only thing I haven't done is clip the anc wire. Gonna try that this weekend but I see people commenting that that wire don't even exist. I'm doing a 2014 impala ltz

This a bogus video