Just finished setting up a V4 gyro with this 3PV remote and thought the same thing about the gyro gain not allowing me to go into the positive gain side (V4 only allowed Red/-settings) BUT I figured out that when you flip the “SW.1” switch that is what allowed me to toggle you then access the positive gain control (Green/Soft mode). Hope this helps someone else!

@RoadsideRC

6 ай бұрын

Awesome! Thank you!

Awesome explanation well-done I just picked this 3pv 💯

@RoadsideRC

Жыл бұрын

Glad it helped!

Wow, my mind is blown .. great info. I knew nothing about setting up a gyro or any of this before watching your channel Troy. I’m still stuck on the 39.00 dumbo’s, or old school futaba stuff

@RoadsideRC

Жыл бұрын

Glad to help!!!

Really well explained. Thanks for posting!

@RoadsideRC

Жыл бұрын

Glad it was helpful! Thank you!

My Futaba 4PM is expected to arrive today, my RDS arrives tomorrow 😆😆Thanks for the video, I was curious about this process! Glad to hear the note at the end that I did the right thing and spent a little extra on my pick

@RoadsideRC

Жыл бұрын

100% I believe the 4PM is worth it over the 3PV. Hope you enjoy the RDS!

Very useful information for rc radio good job

@RoadsideRC

11 ай бұрын

Glad to help!

thank you so much you helped get my redcat back on track. im a little hurt by your review of the t3pv as i literally just bought it. sounds like its not a big upgrade from the stock remote.

@RoadsideRC

Жыл бұрын

It does help a lot compared to the stock controller. I bet you will really enjoy it.

Thanks for all the great videos,,,you should of had affiliate links,,,cause you made me buy a 7pxr

@RoadsideRC

11 ай бұрын

Ha! Yes - that would help for sure. Typically, I do have affiliate links in the video description.

This is going to be very helpful for me I ended up picking up this remote for my drift car and I am awful with electronics I am a total caveman.

@RoadsideRC

Жыл бұрын

Great! Glad to hear it!

I know it’s not the popular option for drifters (seems that Futaba and Sanwa are the go-to choices for higher end drifting), but another great option is the Spektrum DX5C. I would personally avoid the Rugged because of the POS “touch pad”, but the DX5C is really easy to setup and use for drifting. I’m gonna stick with my Futaba, but I started with the DX5C, and never had any complaints with it. If I’m honest, I like the feel better than the Futaba as well.

@RoadsideRC

Жыл бұрын

Oh man! I tried Spektrum, I really did. But was never able to really get it to work correctly.

The 3pv absolutely does ch3 in both directions -100 to +100. I had one and I could easily switch between The red and green modes on a gyd450

@RoadsideRC

Жыл бұрын

I couldn't get this one to do it!!! What did I miss?

@nathanniculae9056

Жыл бұрын

STRM. That’s how it works on mine with a GYD450

@DNZL

Жыл бұрын

@@RoadsideRC on mine it's on system, channel 3

@gianpaolomiraglia5418

Жыл бұрын

@@RoadsideRC leave 3rd channel epa from 100 to 120%, then use the side slide button (you have 3 trims buttons on the side of wheel) to setup gyro from +100 to -100 to have both modes on gyro. If doesn't happen, go into menu and setup properly channel 3 mode (read manual ;) )

@devondunkz

6 ай бұрын

Will this work with my yokomo rtr

AVCS for the gyro is buried in the SYS menu a few layers deep. CH3 I believe. its the last option in the SYS menu before skipping to TRM

@RoadsideRC

Жыл бұрын

Thanks!

Unfortunately my stock controller for my RMX for was faulty so I bought the 3pv as a replacement and it has been nothing but great for me

@RoadsideRC

Жыл бұрын

Awesome! Glad to hear it!

@RyanLumRC

11 ай бұрын

Hey bro I'm trying to get my RMX 2.5 set with my futaba 3pv , I got no reverse at all , calibrated it all that . What do I do ???

Boy do I wish you made this 3 weeks ago lol! It's a pain setting up lol.

@RoadsideRC

Жыл бұрын

Did you get it finished now?

@B20V-SOL

Жыл бұрын

@@RoadsideRCYes sir!

I'm running a noble Pro, I like that you can set channel frequency individually as my stuff support SR mode. Since you have both, personal preference between 4PM and NB4 ? Why?

@RoadsideRC

Жыл бұрын

That is really a tough question!!! For me - both controllers do everything I want them to do. The Noble gets extra points for the included power bank. The Futaba gets extra points for overall feel. I think both are a great choice.

Hi Troy. I always appreciate your drifting videos. How does the RedCat RDS compare to the MST RMX 2.0/2.5 RTR??

@RoadsideRC

Жыл бұрын

Video coming out soon on exactly that!!!

@frozenshade666

Жыл бұрын

have not hold the RDS in my hand, but for what you get out of the box, RDS all the way. But, if you like the bling, as of right now, support for aftermarket is none existent out of what will fit on most chassis.

@mikecabardo

Жыл бұрын

@@frozenshade666 my MST RTR drifts great out of the box. I have the 2.0 which is not very tunable but the 2.5 I heard is. RDS looks promising, but it seems like you need to tune it quite a bit to drift nice.

Hey Troy, I bought the 3PV for my MST and my servo does not work when the power comes on. It’s hard to the touch so you can’t freely steer the wheels with your fingers. Do you think it would be my servo or I just didn’t do it right? I did everything the same way you did if that helps

@RoadsideRC

Жыл бұрын

Something isn't setup right or plugged in right. Please double-check the connections.

So if I have my steering in 1 and esc in 2, where do I plug my motor fan into ?

@RoadsideRC

4 ай бұрын

Any free location - it doesn't matter.

Have you done a vid on the futaba 4 channel t4pm? Ive just got a reve d and getting started

@RoadsideRC

Ай бұрын

The previous model, the T4PV was actually my main controller for quite awhile. So, whenever I tested new components - they were setup using that controller. Example: kzread.info/dash/bejne/oJ5rzqqzeZOaeLA.html

Question! I have a redcat RDS and I've got the 3pv and I'm setting it up and I cannot go into reverse! I've done everything you said to do in the video and idk what's going on? You have any answers that can help

@RoadsideRC

8 ай бұрын

Are you using the RTR esc? Typically a lack of reverse is due to either 1) a setting in the ESC to remove reverse, or 2) a poorly calibrated controller to ESC.

Hey bud I have a rmx2.5 with stock gyro and servo and was setting it up and my epa on the same controller you have and it's only + 0 to 100 no - so I when I turn it to +0 it's still fast. Gyro never stops or slows down. Also I just bought a gyd470 will that work with stock servo. Have not installed yet and this radio. Thanks.

@RoadsideRC

10 ай бұрын

Yes, that is one limitation of the 3PV. You need to reverse the channel 3, and then it will work.

If you use the Ch3 Trim instead of Ch3 EPA, you can go positive or negative. Leave EPA maxed on Ch3.

@RoadsideRC

Жыл бұрын

That is odd - but I will 100% try it! Thanks!

@DNZL

Жыл бұрын

I use ch3 in the system tab. You can also assign ch3 to sw1 on your controller, and switch between avcs en normal mode like that. But then it's locked at 100%

@pothole0222

Жыл бұрын

I was just coming in to say this. That’s exactly how I set up my 3pv in my mst.

@robinkesterlives

Жыл бұрын

I literally just did this on my setup, noticing that the CH3 adjustment was up to the limit of the CH3 trim top end. Saved my sanity figuring that out lol :D

Can you put a 13.5 in or 10.5 and see if the gears can handle some boost and turbo?

@RoadsideRC

Жыл бұрын

Coming soon!!!

Hello Troy! I have T4PM plus and I have couple of secnds throthle delay after useing reverse. Is it some redio setting I have to change or adjust? Have been trying to solve this but still there is 2-3 second delay. What might be wrong. Everything eelse works fine.

@RoadsideRC

Жыл бұрын

I have not had this issue when the throttle has been calibrated with the eac correctly. Please give that another shot and make sure it works. Otherwise, the esc should be set to forward/brake/reverse, which means you need to double-tap the brake to get to reverse.

@mika_models

Жыл бұрын

@@RoadsideRC I solved the issue. I have sensored motor, Hobbywing D10 and sensor wire was bad. I solder couple of those tiny wires and that delay is gone. But Thanks anyway for your comment. Appreciate it.

@RoadsideRC

Жыл бұрын

@Mika Kultanen Ah! That makes sense. Glad you fixed it.

Does the stock gyro Hexfly Gx1 adjust between avcs and regular mode? I have the NB4 Noble and can’t seem to get it to change modes on the fly.

@RoadsideRC

Жыл бұрын

Here is how you do it! See at the 0:33 second mark: kzread.info/dash/bejne/mY2IzaeaiNzAfc4.html

@deeooo2

Жыл бұрын

Thank you for that info. I was thinking with the Noble I could use positive and negative gain to switch between avcs and regular gyro gain. It’s my first drift car so I still have a lot to learn.

I've been looking into the noble nb4, however I did notice that it's been discontinued do you have an alternative recommendation similar or would you still recommend the futaba 4 channel

@RoadsideRC

Ай бұрын

I still see the Noble for sale. I don't think it has been discontinued...

@joespafford6499

Ай бұрын

@@RoadsideRC I did dig a little more and found some, one was called a Google. Noble nb4, same transmitter. Thank you for your response 🙏🏼

what would you recommend between futaba 3pv / futaba 4pm / flysky noble nb4?

@RoadsideRC

4 ай бұрын

Both the 4PM and NB4 are VASTLY better than the 3PV. Between those two, it is all just personal preference.

Hi troy love your channel do you think this can be done on the sanwa mx6 the same way as always conflict of info on the net as always 😂

@RoadsideRC

Жыл бұрын

I'm sorry, but I have never setup a Sanwa radio, so can't directly say.

@ricjackson1

Жыл бұрын

Appreciate your honesty I guess il have to get one and try it if it works I will do a video for everybody and share good info like yourself

@RoadsideRC

Жыл бұрын

@@ricjackson1 That would be great!

Hi friend! Thank you for your video, just one comment, at the end you say that you recommend spend a few more bucks and buy a 4PM or a Noble intead of the 3PV, but this "a few more bucks" is twice the price of 3PV...

@RoadsideRC

8 ай бұрын

Correct - unfortunately, the good controllers really do cost more.

Could you also use this with VRC racing simulator

@RoadsideRC

11 ай бұрын

I never tried, but believe some people do.

hi i recently purchased a 3pv controller, would it work with the Futaba 550 gyro?

@RoadsideRC

Жыл бұрын

Yes - but it will not allow all of the tuning features. I have a video coming out on the GYD550 soon!

@josearios91

Жыл бұрын

@@RoadsideRC cant wait to see it

Can u do a video explain the buttons on the remote I messed with them and now my car doesn’t run right 😅

@RoadsideRC

9 ай бұрын

Check the manual - I would suggest doing a full factory reset unless you can figure out what you did.

How do you bind the remote and the receiver ?

@RoadsideRC

2 ай бұрын

Hello! I would love to help you - but writing that out here would be difficult. The manual for the controller (found on Futaba USA website) shows you step-by-step on how to bind them. (Page14 - referenced as "linking")

Brilliant But Very Expensive Transmitter I Was Going To Use The RTS8

@RoadsideRC

3 ай бұрын

In the RC drift world, the Futaba 3PV is actually one of the cheaper transmitters that people use. I am not familiar with the RTS8 - do you have more info on it?

@SurRon-GLE

3 ай бұрын

@@RoadsideRC Sorry I ment say RLAARLO CT-8A and Receiver.