OSHA would have a field day on this job

Looks great

@brianrobbins3499

3 жыл бұрын

Hack job all the way

You don’t cut a curb in at the top, as the roof expands and contracts this will tear and cause leaks, proper installation is either over/over or under/under. 2.5” mastic gasket is the only way to water proof a commercial roof curb. Silicone will oxidized galvalume roof panels and void manufacture warranty. Roof curbs should be installed as roof is installed under/under for best results. Over/ over is for retrofit applications. 20 years experience certified PEMB roof installer.

@franciscobonilla7323

Жыл бұрын

Lucas, you have any videos for over/over install?

@MrAllister9

Жыл бұрын

when you mark where to cut the deck .. we have a 8" roof because the foam insulation in between do i use a long metal bit to mark from underneat ? I really dont want to make mistakes

@lucasusry8199

Жыл бұрын

@@MrAllister9 yes

Fantastic video! Looks like a dollsr general store, or family dollar

Excelente trabajo podrás hacer video o tendras fotos de preparación por debajo de rooftop

Finally, someone showing how a roof curb goes on a standing seam roof. Pass the silicone sealant over here. We gonna need it!

Standing Seam concealed fastening system gets a non concealed roof jack.?

Were Grinders not invented when this was produced? Secondly epic fail unless the curb is getting an adapter because i didnt see any sort of leveling

@1:02 why is there a man dancing around the open hole with a red hankerchief with no harness on him? he is going to trip and fall into the hole. If I saw this on one of my jobs, the job would stop until this is followed and understood. For the installation detail, I would have removed the standing seam roof panels, installed the curb, then put the roof back on. One summer with this roof heating up and cooling down, expanding and contracting, and it will leak at every seam here. (architect since 2004)

If i wanted a music video i'd go to tiktok

Where do you find the caps for a r panel I'm installing curves now and cannot seem to find any

@BuildingwithNARF

8 ай бұрын

Fabricator of the curb supplies the caps as to which roof panel is used.

What is the sealing tape you used?

@BuildingwithNARF

Жыл бұрын

It is a Butyl tape. Very good stuff.

HOW DID YOU INSTALL THE EQUIPMENT TO THE CURB?

@BuildingwithNARF

10 ай бұрын

Not my work ..HvAC guys did that part.

typical Iron works

You should’ve went further up roof to where screws are in beam. Take screws out , push curb up instead of fighting it🤙🏽… put back those screws 🙃 P.S. curb should go on top of both highs on each side

@bleach8419

Жыл бұрын

ps those screws are not in a beam they are holding a pan on the bottom panel and if you take them out said pan falls out

Do you have IG? I have a question for a pro and I will pay for the answer.

@BuildingwithNARF

3 жыл бұрын

NARF.Buildz

The title should be how to frig up a metal roof JUST SCREW INTO THE FLAT PART OF THE SHEETING INSTEAD OF THE RIBS.

Where’s the fall protection ?

@BuildingwithNARF

Жыл бұрын

Fall? 🤔I learned to stand up right after I learned to crawl.😉

@ThermalSolutionsHVACR

8 ай бұрын

That's for wussies

@3:41 no harness in a scissor lift? Naughty, naughty.

Das Wasser fließt wohl anders in Amerika, als in Deutschland.

i wanted to see how you guys marked the rtu hole from underneath ... but you skipped it all .. im doing a roof with q deck and gravel on top and its 8" cause the foam in between ... i would just use a long bit from underneath and drill though kinda thing?

@BuildingwithNARF

Жыл бұрын

We had the hole framed and when we installed the roof we marked location of the hole at that time.

Si trabajaran para las compañias que yo les hago metal en el primer trabajo estan despedidos eso no va asi ese trabajo wsta muy mal

@ThermalSolutionsHVACR

8 ай бұрын

Cada compañía tiene diferentes estándares.

I think I will leave the metal intact and forget the skylight

@BuildingwithNARF

7 ай бұрын

Great choice.... Skylights usually leak within 5-10 yrs.

Execução do trabalho horrível, parece não saber fazer a instalação. Duvido não ter vazamento