Thank you for this video. I'm getting ready to do this on my 2015 rear hub.

Thank you a lot for the video

Instead of using a puller you can leave the 4 bolts you removed from the back of the hub out a few turns and then hit your sledge on the back of your socket and extension to get a gap started between the hub and the knuckle. Then remove your 4 bolts all the way and hopefully hand pull the hub off with only a few light taps or none at all.

Where's part 2? I have the same problem same year too.

@MidknightMechanics

4 жыл бұрын

Reverse of the uninstall my friend. It's very straight forward. Just don't forget, after you torque the axle nut with the car's weight on the ground right through the wheel's center cap- get it back up in the air, pull the wheel off again, to reinstall the cotter pin.

Would this work on previous year’s pathfinder/xterras since they shared differentials?

Hi do you have a part 2. To this video? It just stopped at 17. Mins lol. Job not finish lol

2013 pathfinder, nice video, my is startimg humming. I cant tell where from. Do I test the hub by the traditional way of moving the tire side to side with my hands?

@MidknightMechanics

3 жыл бұрын

Unfortunately moving the wheel side to side only checks tie rods, and up to down usually only checks ball joints/control arms. One of the most effective ways to check for wheel bearing is, If you think it's the driver side front for example, take a sharp left hand corner and listen for the sound of the humming to minimize or disappear. This is called unloading the suspension, which takes a majority of energy & weight off that corner, which will greatly change the sound of the failing wheel bearing/hub.

@arturodurantrejo1260

3 жыл бұрын

@@MidknightMechanics thank you very much.

having a hard time finding the torque specs for a 2014 pathfinder

Does it need an alignment after changing the hub in the rear? Not changing any suspension geometry, right?

@robertmanshack4023

3 күн бұрын

You should not need an alignment on this part replacement.

What size impact driver is that?

@MidknightMechanics

3 жыл бұрын

Nate, 1/2". Best and most powerful i've ever had.