How to Fix A Square Baler Broken Shear Pin And Reset
Тәжірибелік нұсқаулар және стиль
Normally this happens in the field and it's way to hectic to film. I had the chance to do it before it happens this season so here we go. How to reset the baler after it breaks and all that jazz.
Welcome to Man Time!
Пікірлер: 14
Been learning about my baler from your videos. All the best Thanks for sharing what you learned.
Just subscribed
Well, you are partially correct, baling to green to quick is part of the problem. There is a clutch assembly under the cowling on the pto shaft before the flywheel. Your clutch should be able to slip if you are wadding up. Shearing pins means your clutch is seized or worn out . Check it out.
@Man-Time
2 ай бұрын
Dang must have missed that in the manual. Very helpful Man!
@thecdn3561
2 ай бұрын
@Man-Time You're welcome, we had a john deere and New holland if we were going through pins it was usually because of the clutch assembly. Best of luck 👍 hope it solves the problem.
@kathyfrisby4757
Ай бұрын
I just put a new clutch on my PTO we are trying to make some test bales manual feeding so it wasn’t too much hay going in at one time. Should I back off on the tension before I try it again?
@thecdn3561
Ай бұрын
Yes, just a little, you want the clutch to work but not become irritating by constantly slipping. Best to check manufacturers' specs on tension for the clutch assembly.
@thecdn3561
Ай бұрын
Sorry Kathy, I should have started off saying hello first. You don't want your clutch plates or clutch under too much pressure. Like I said, best to check manual or manufacturers' recommendations. Happy baling.
We use Okbrand 14.5 gauge wire, but dad feels like the circumference of the wire is too big. We break down all the time. He wonders if the wire we are using is the problem. He lost a field of hay due to not getting it working in a time crunch. Any advice on that?
@Man-Time
Ай бұрын
Sorry to hear about your loss. Been there before. I would say the least likely reason for a failure is the wire. Running too fast through the field is my main cause of failure. Overloading the baler
Is it normal to shear the bolt on the twisters
@Man-Time
10 ай бұрын
Never happened to me
Plot twist: Installs chainsaw bar on baler - now able to cut & bale firewood! 😁