No video
How to FIX a 3D Scan Building - Zbrush and 3D Coat
This video shows a scan done only with a small drone, a DJI Spark. Due to the lack of features on the walls, it needed to be fixed... here's my solution to do it..
Here it is a link for you to see it on sketchfab:
skfb.ly/onApF
Equipment used to capture this:
DJI Spark
Software used:
Lightroom
Agisoft Metashape
Zbrush
3D Coat
Thank you for your time, hope you liked this ;)
#agisoftmetashape #sketchfab #dronephotogrammetry
Пікірлер: 7
I always wondered how to do it , thanks for letting us know :)
@CarlosFaustino
3 жыл бұрын
you are welcome, i was learning as well while i was doing this so... just sharing the knowledge with the rest :)
ok, deleting the whole walls works, but I would usually just use Smoothen in Blender or move some of the troubling vertices manually
@CarlosFaustino
3 жыл бұрын
Well just fyi... The mesh was around 2M polys and after that it Turn out 1,2M polys... So... Not just a few vertices... And already tried to smooth on zbrush and didnt get the best results and was taking way longer than this approach
Wow this is awesome.. do you have tutorial zbrush for photogrammetry? noob guide or explain tools you use often in zbrush
@CarlosFaustino
3 жыл бұрын
well, it wont be on the next video because its being made already but after that one, i'll make a zbrush for photogrammetry special video commented and slower :D
@watashiwastevedesu6928
Жыл бұрын
@@CarlosFaustino link?