How To Diagnose A DPF Diesel Particulate Filter Differential Pressure Sensor & Test Hose Pipes
Автокөліктер мен көлік құралдары
here we have a vehicle where two people have tried to do DPF cleaning to resolve a flashing glow plug problem and DPF Fault codes
blocked DPF pressure hoses that lead to the differential pressure sensor tubes was the primary cause of the fault
tools used were...
Autool digital manometer
mityvac pressure tester gauge
Autel MK906BT
plumbers blowtorch
Пікірлер: 58
Another billiant video. No waffle, solid explanations of the 'what' and 'why. Surely the best YT channel for DPF related issues?
@ORileysAutos
5 ай бұрын
Thank you
@FatHead1979
5 ай бұрын
@@ORileysAutos You're welcome mate, keep up the good work 💪
Thanks Jimmy your videos and helps are helping me a lot in my mobile mechanics business , always new stuff to learn and new tools to get 👍
@ORileysAutos
Жыл бұрын
Thanks a lot 👍🏻
Nice one Jimmy,thanks👍
Great video Jimmy, helped me sort out my Peugeot 307. Thanks mate 👍
@ORileysAutos
Жыл бұрын
Glad it helped
Excellent thanks 🙏 ☘️🇮🇪
Great job Jimmy ☘️🥃💚👍
@ORileysAutos
Жыл бұрын
Cheers 👍🏻
Top job Jimmy 👊👊👊
@ORileysAutos
Жыл бұрын
Thank you
Nice one. Just got a new sensor (wasn't too expensive) but if it doesn't solve it, then will run through this.
Love your videos and help you give in the videos I’ve been watching I’ve watching them for sometime now I have a 2006 be crafter that has had a number of issues I’ve been working on related to the DPF and it seems almost every vehicle fitted with one has issues with them at some point ! Do you think it’s time the manufacturers Do a recall on them and offer a better usable solution! To the problem Big thanks kev
I am getting and intermittent Fault on my X358 Jag. removed one of the pipes and put a cleaner through the dpf, refitted the pipe and still getting the fault. Next stop to do as you did on this one. Thanks
There was dead tube (just ruined into small pieces :) ) on renault laguna III, after DPF. Replaced to another 6mm for fuel, but error still exists and see that diff. pressure is 0 or -1. Will check if not blocked tube (metal) to DPF or if sensor reacts to pressure in rubber tube from that join. The amount of ash in dpf renault canclip shows about 27grams, have to hurry up :)
Your videos are like crack 😂 so addictive
Good stuff 🙂
@ORileysAutos
Жыл бұрын
Thanks
I wish you were local to me !!!!!
good job
@ORileysAutos
Жыл бұрын
Thank you 😊
Awesome video and just what I needed. I have a P2453 code on a BMW X2 X Drive 20d, do you know where the sensor is located on this vehicle? Any help would be greatly appreciated.
can you give me an idea what to check? I checked the hoses, replaced the pressure sensor to be sure is ok, seems fine, I got a value ~7mbar at idle and ~20mbar @ 3000rpm. What I dont get it, is why is regenerating if DPF is clean (I also take it out and give it a deep clean even before cleaning was not clogged and was regenerating ~ every 50 km and then reprogram as I have change it), and acc. calculation it is showed ~40% normal clogging. I is normal to regenerate often (500km interval in city conditions) even if is not clogged?
Hi Jimmy, I have an issue with my vauxhall zafria b where it keeps stalling when idle (after 10-30 seconds) and whilst slowing down to stop it will cut out unless i keep the revs up higher than 1k. I have been told its my DPF and needs replacing. Its currently at 96% saturation but when i just connected it to opcom the DPF sensor doesnt seem to be moving up very much. Could it be just blocked pipes rather than having to replace the DPF? 😮 Cheers
Hello Jimmy. If i want to replace the DPF sensor on my 2016 Passat B8 should I remove the whole DPF from the car or is it possible without removing it. Thanks in advamce
Hello, nice video. What should be normal dpf diference presure reading? On idle or on some rev in car? In case if sensor and lines are not clogged. How to tell if there is need to start worry about.
Is it ever normal to have a differential pressure sensor report negative when engine is off?
Do the same rules apply to cdpf?
Can i have a bit of help, On live data dps presure 0.5 kpa, when car its started or runing, dpf presure its 0. All pipes checked new dpf sensor changed. Error p2002 Any advice
Hi great video as always. I’ve recently changed a faulty Dpf sensor on a Tiguan. Live data shows 2 sensors (there is only 1) should the readings be the same? Cheers
@kevinhancock4064
8 ай бұрын
What symptoms did u have pal ?
@markraz28
8 ай бұрын
Ah mate can’t remember properly. Pretty sure was a code for implausibility signal for dpf sensor. Eml was on and think in limp mode. Wiring was all good. New genuine sensor sorted it. Sorry for the vagueness 😂.
@kevinhancock4064
8 ай бұрын
@markraz28 ah ok buddy thank u waantvsure if u had frequent regens ty
@markraz28
8 ай бұрын
No maté definitely wasn’t doing that. Just limp mode
Great video. By the way, what pressure side this sensor reads, upstream or downstream?
@madds6678
Жыл бұрын
It’d be upstream checking pressure build up in front of the dpf. Most modern cars have a differential pressure sensor that checks before & after (as in the word differential), older simpler systems just have a pressure sensor in front.
@redouanemanaa
Жыл бұрын
@@madds6678 Thanks for your reply. Mine is Insignia A20DTJ 2010
A1+
On our fiat ducato ambulances I see -1 0r -2 with ignition on not 0 does that mean a pipe blocked or starting ?
@russbridges9614
Жыл бұрын
Hi, take the pipes off so sensor is at atmospheric pressure ie zero and see what it says then, if still 1 or 2 then sensor could be faulty or just needs calibration
Nice 1 mate your theory on to frquent regens ? Ty
@ORileysAutos
8 ай бұрын
Ash build up or damaged DPF
@kevinhancock4064
8 ай бұрын
@@ORileysAutos hmmm great I'd have tho8ght I'd have more symptoms from that
@kevinhancock4064
8 ай бұрын
@ORileysAutos you'd think if it were blocked it wouod not complete a regen ?
@kevinhancock4064
8 ай бұрын
@ORileysAutos I just looked at 1 of yoir dpf pressure videos I'm wondering it it's that ? I'll check the hoses etc imc pressure mate let you know great videos
Also what model is mitivac bud?
@ORileysAutos
Жыл бұрын
Mv8500
Jimmy what would cause a forced regeneration to go no further than 20 percent ?
@ORileysAutos
Жыл бұрын
Is it stopping because it's saying unsuccessful?
@davidwaters5348
Жыл бұрын
@@ORileysAutos yes saying unsuccessful
@ORileysAutos
Жыл бұрын
@@davidwaters5348 lots of reasons. What vehicle is it
@davidwaters5348
Жыл бұрын
@@ORileysAutos 2012 megane 1.5 dci
@ORileysAutos
Жыл бұрын
@@davidwaters5348 did you watch my video on the mercedes b class with same engine
Wouldnt it have been quicker and easier to put a long drill through the blockage!