Best explanation :)

One of the best video for FIREWALL BIGNNER , THANKS SIR

how to make two ISP with different network sir? I Just put 1 ISP with Management cloud, in vmware i'm just user virtual network adapter vmware vm0 pair with my wireless device in laptop. Can you tell me? Thank you very much

Good brother step by step explanation i liked 👌👍

@NetSecBoy

Жыл бұрын

thanks brother! goodluck on your studies

Great video. But how can you create a health check on the next hops so that it failovers even when the fifical interface remains up without having to use sdwan?

Please provide more videos, I will recommend yours videos to my friends 👍👍👍

@NetSecBoy

10 ай бұрын

Thank you brother! I'll create more videos and share my knowledge. I'm just studying Juniper SRX.

Nice video, however you did not include the Router config for interface e0/1, how do you have two ISPs? Are you using the NAT network in eve-ng then do ip address dhcp on the e0/1 interface to get the 172.29.129.x address that can go out to the internet?

great video but bro as this video is for beginner so if you could mention the router and switch configuration it will be very helpful thanks

@NetSecBoy

8 ай бұрын

sure bro I will create a video for this one "router on a stick" or Roas

How can I setup homelab to learn Fortinet firewall configuration?

@silasinfotech

4 ай бұрын

kzread.info/dash/bejne/dGRnxtqndrPSk9Y.htmlsi=Qs29AM7lti1c5Uv5

for windows 10 images bro

how the traffic pass to second ISP, the firewall policy you given Outgoing interface Wan-1, how the traffic switch to second Isp. AD distance for only static route.

@NetSecBoy

11 ай бұрын

hi @ferozsyed2014, this video shows only how to create static routes on FortiGate Firewall and a simple failover. To answer your question, the traffic goes to second ISP once the primary ISP goes down and when it goes up again the traffic will go back to the primary. Just remember in FortiGate static route AD lowest value is preferred for the routing table.

@ferozsyed2014

11 ай бұрын

@@NetSecBoy thanks for your reply.

@rakuntal100

5 ай бұрын

@@NetSecBoy But you have not configured the link health monitor. In case of primary link failure, how would it switch to secondary link automatically?

Failover with sd wan can combine?

@NetSecBoy

Жыл бұрын

Hi Stanley, no sdwan configured on this lab, just a simple static route failover with lower and higher distance on it.

@stanleygalaxy5333

Жыл бұрын

@@NetSecBoy hi sir really appreciate your reply thank you

@NetSecBoy

Жыл бұрын

@@stanleygalaxy5333 happy to help

Please provide sound, so we can uderstand better 👍👍👍

Eve- ng 👍👍😘😘