I had a few sharks posing as mechanics convinced me to throw parts at my Yukon Denali. They overlooked bad spark plugs and went straight for fuel injectors, throttle body and sensor, MAF sensor and ignition coils. After all of that I was still getting misfire codes on cylinder 6, and I took it upon myself to swap the plug and wire on 6 and wala I’m running like a champ... I appreciate you online mechanics, you guys are doing God’s work with these tutorials and walk throughs. Thanks

I like to blow each plug hole out with compressed air prior to removing the plug. This will get rid of any sand/dust that could find it's way into the cylinder

@All4HimRacingVideos

Жыл бұрын

Great point!

Thanks bud, tutorial was very easy to follow along with.

Thank you for your time and effort making this video, You did a great job with the instruction . American Iron all the way!

Thank you. Cost me $9.76 Sparkplug+grease. I disconnected my battery not sure if that was necessary but it was recommended. Replaced the sparkplug for cylinder 7. Truck runs great again. Appreciate this video!

@All4HimRacingVideos

3 жыл бұрын

Glad you were able to get it fixed!

- Spark plug boot tool useful to prevent damage from pliers. - Thread length looked different on new plugs? - I would not trust pre-gapped plugs due to shipping, dropping & returns.Can gently check with gap tool.

Was just asking a buddy this morning about using any kind of lube on replacement spark plugs for my 6.0 GM boat motors...helpful tip on this subject, thank!

Great video as well as good info from comment help !! Thanks!!

@All4HimRacingVideos

4 жыл бұрын

You're welcome! Glad it was helpful

Best video by far!

Passenger side is easier to get if you remove the front tire. Direct access to the 2 rear plugs

@pacsoulpavon9649

4 жыл бұрын

LSX_KINGPIN hey I see you have a tbss , I also have one and it’s the reason why I’m here . Do I have to disconnect my battery to change the plugs ? And what plugs do you recommend

@All4HimRacingVideos

4 жыл бұрын

Good suggestion!

@Strykker23

4 жыл бұрын

@@pacsoulpavon9649 don't have to unplug the battery and depending on your engine setup you can go with different versions of NGK Plugs. Stock engine is NGK TR5-2238

@pacsoulpavon9649

4 жыл бұрын

Coach Emmett thank you appreciate the respond , my engine is a 6.0 ls2 stock so I will be doing that in the coming week

@seanrichardson2986

4 жыл бұрын

Gotta atleast check the gap!! Never put them in with out checking the gap!!! 👎👎

Thank you for your help. God bless you sir

@All4HimRacingVideos

3 жыл бұрын

You're welcome!

2:30 dam a squirrel. That has to be a rare thing. He had to hungry haha

Just picked up a 2011 Silverado 3500 6.0 at auction with 170k. Truck runs good no codes, had it serviced ( oil& multipoint inspection) at local dealership no issues found also I changed air filter. All that being said and not knowing the history on the truck (one of the downsides to buying auction rigs) I'm thinking at a minimum plugs and wires, question would be with these miles do the coils as well or wait?

Thank you!

@All4HimRacingVideos

11 ай бұрын

You're welcome! Good luck with your project

Hey, so the manual says to use ACDelco 41-962, but some people say to use ACDelco 41-110. I've been using the 41-110 and I've had to change the knock sensor three times already. The engine light is still on. What do you think I should do?

Good info. Thx

@All4HimRacingVideos

4 жыл бұрын

Glad it was helpful!

Why would my boot come off the spark plug . ?where the heat shield insets

Is there any downside to still putting some dielectric grease on there just in case?

@All4HimRacingVideos

Жыл бұрын

On my opinion it comes down to personal preference. Ask 10 people get 10 different answers

what is the proper spark plug gap for the 6.0 vortecmax aka HO motor? ive heard both 60 and 45..

@leonardomerino8167

Жыл бұрын

Following... manual says .60 but only find videos with .40

Any help for an idiot who decided to take all of the plugs and wires out at the same time and now has no idea how the new ones in the correct order. 00 gmc sierra 2500 6.0

@Kelvin_-qs3uz

Жыл бұрын

Haha 5 months later, u ever got it?

@Millzspec

Жыл бұрын

@@Kelvin_-qs3uz turns out my truck doesn't have a specific order just plug and go

How do you make the sparkplug fire 2003chvevy truck everything is wotk÷

Damn squirrels

What is the torque for the plugs?

@All4HimRacingVideos

3 жыл бұрын

Been a while since I filmed this but manuals online state "Spark Plug Torque 15 Nm (11 lb ft)"

@YaRight2986

3 жыл бұрын

Thanks!

@maddexxx847

Жыл бұрын

About 3 ugga duggas

Wires won't come off